A refrigerant leak may develop from one or more of the following AC components: AC compressor, hose manifold for the compressor, or the evaporator core. The loss of refrigerant can cause poor AC performance. Our technicians tell us that proper leak diagnoses should be performed in order to determine the cause of any refrigerant loss.
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported Mercedes-Benz 300SD problems
Other than a defective motor, a bad switch or blower motor resistor assembly can cause an inoperative heater blower motor.
The lower control arm bushings can wear and crack, leading to irregular and premature tire wear. Worn Ball joints can also cause similar tire wear problems. I some cases it may be necessary to replace the lower control arm, including bushings & ball joint to correct this concern.
The head lamp wipers are easily damaged, especially by automatic car washes.
The lenses for head lights may become opaque (cloudy or hazy) as a result of sun exposure. This can reduce the effectiveness of the lights. Our technicians tell us plastic polishes can improve the clarity of the lenses, but replacement of the lamp housings is necessary to regain full intensity of the lights.
The climate control system can fail or perform erratically due to internal problems with the climate control button electrical contacts. Replacement of the climate control assembly is commonly required to correct this problem.
Vehicles with automatic level control that ride harshly in the rear (no give in the suspension) may have one or both dampening actuators which have failed. It is commonly recommended the actuators be replaced in pairs.
The battery can leak acid onto the engine compartment wiring harness, causing damage to the wiring from corrosion.
Problems with the pneumatic system can cause closing assist and door lock issues.
High mileage vehicles may develop a transmission fluid leak from one or more of the oil seals.
A worn steering dampening shock can cause a fluid leak at the front of the vehicle. If a leak is noted from the dampening shock, our technicians tell us that it should be replaced.
A cracked or broken heater core outlet housing can cause a coolant leak near the bulkhead (firewall). Our technicians remind us that coolant leaks should be repaired in order to avoid overheating the engine due to coolant loss.
The tie rod ends, idler arm, and/or drag link components of the steering linkage may wear prematurely. Please keep in mind the wheel alignment should be checked and adjusted when any of these items are replaced.
The brakes may begin to squeak at about the 50 percent wear point. This is due to the size and material used for the brake pads and rotors. The brake rotor surfaces become uneven, causing a lip to form at the outer edge. This will generally require replacement of the rotors when the pads are worn (pad life varies depending on driving style and terrain).