Lexus Problem Reports

RepairPal Verified Lexus Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

A shift "lag" may be noted when accelerating from speeds of 10 to 20 mph. A software update for the transmission control module has been released which may correct this concern. Software updates are commonly most effective on newer vehicles. Higher mileage vehicles may exhibit a similar symptom caused by a component failure. However, whenever major transmission repairs are performed the transmission software should be checked and updated as necessary.

There are reports of intermittent failures with the heating and air conditioning control. The digital display might fail or the control might fail to switch between heater functions.

There are reports of intermittent failures with the heating and air conditioning control. The digital display might fail or the control might fail to switch between heater functions.

A clunk type noise may be noted from the rear of the vehicle just before or just after coming to a stop. Our Technicians tell us a revised rear driveshaft and rear suspension control arms are available to correct this concern.

The airbag warning light may illuminate whit code B0111 and/or B0116 stored. Our technicians tell us the an updated wiring harness is available which should correct this concern.

The supplemental restraints system (SRS) warning light may illuminate with code B0111 and/or B0116. Our technicians tell us Lexus has several service bulletins regarding the SRS system. It is not uncommon to replace one or more airbags to correct these fault codes.

The supplemental restraints system (SRS) warning light may illuminate with code B0111 and/or B0116. Our technicians tell us Lexus has several service bulletins regarding the SRS system. It is not uncommon to replace one or more airbags to correct these fault codes.

The front suspension might make noise when going over bumps or rough roads. The support bushing for the suspension commonly needs to be replaced to correct this concern.

Intermittent failure of the purge control valve in the evaporative emissions (EVAP) system may cause the Check Engine Light light to illuminate.

The Check Engine Light may illuminate because the mass air flow sensor sends incorrect information to the engine control computer. This can cause a loss of power on acceleration. A failed mass air flow sensor will require replacement.

The Check Engine Light may illuminate because the mass air flow sensor sends incorrect information to the engine control computer. This can cause a loss of power on acceleration. A failed mass air flow sensor will require replacement.

The Check Engine Light may illuminate because the mass air flow sensor sends incorrect information to the engine control computer. This can cause a loss of power on acceleration. A failed mass air flow sensor will require replacement.

The Check Engine Light may come on because a component of the oxygen sensor stops working. Replacement of the failed sensor should correct this concern.

The head gasket will fail if the cooling system is not serviced with the recommended frequency or if the car is driven when overheated.

A knocking noise may develop from the AC compressor. Our technicians tell us a redesigned compressor is available to correct this issue.