» »

Problems for specific Land Rover Range Rover years:

Car problem reports

Report A Problem

Problem with your car? See what our experts say or submit your own.

Repairpal verified Land Rover Range Rover problems

 

Verified for the Land Rover Range Rover

A driveline vibration may be noted, mostly at idle. Our technicians tell us a revised right side engine mount is available which should help with this concern.

1 Report
Me Too

Verified for the Land Rover Range Rover

Oil leaks from the valve cover gaskets are not uncommon. Our technicians tell us that if one valve cover seal is found leaking both valve covers should be resealed to try and avoid future issues.

3 Reports
Me Too

Verified for the Land Rover Range Rover

A water leak may develop from the sunroof area. The is commonly caused by kinked or pinched sunroof drains. Our technicians tell us the drain tubes should be inspected and correctly routed to correct this issue.

1 Report
Me Too

Verified for the Land Rover Range Rover

A clunk type noise may be noted while turning left or right at slow speeds. Our technicians tell us this noise is commonly caused by the intermediate steering shaft, a revised intermediate shaft is available to correct this concern.

3 Reports
Me Too

Verified for the Land Rover Range Rover

A clunk type noise may be noted from the drivetrain when the throttle is released and applied. Our technicians tell us the powertrain control module (PCM) software can be updated to correct this concern.

2 Reports
Me Too

Verified for the Land Rover Range Rover

The parking brake may develop a screeching noise or fail to release. Our technicians tell us the is commonly caused by the parking brake cable being out of adjustment or failure of the parking break actuator. Cable adjustment and/or actuator replacement would be necessary to correct this concern.

5 Reports
Me Too

Verified for the Land Rover Range Rover

Black smoke from the exhaust, poor acceleration, and/or a rough engine idle may be a result of corrosion affecting the exhaust gas recirculation (EGR) valve operation. Replacement of the faulty EGR valve would be required to correct this issue.

5 Reports
Me Too

Verified for the Land Rover Range Rover

The air suspension inactive message may be displayed with fault code 41 stored. Our technicians tell us the air suspension electronic control unit (ECU) software should be updated prior to attempting to diagnose this concern.

3 Reports
Me Too

Verified for the Land Rover Range Rover

A pulsation may be noted upon brake application. This condition is commonly caused by warped brake rotors. Our technicians recommend inspecting both front and rear brake rotors when this condition occurs. Brake pads should be replaced along with any warped rotors to correct this condition.

22 Reports
Me Too

Verified for the Land Rover Range Rover

In severe wet conditions, water may enter the anti-lock brake system (ABS) modulator electrical connector resulting in corrosion and illumination of the ABS warning light. Our technicians tell us revised modulator ground leads are available to better seal the connector. If corrosion is found in the electrical connector the connector will need to be repaired as necessary and the new ground leads installed.

12 Reports
Me Too

Verified for the Land Rover Range Rover

One or both power folding mirrors may not fold in or out correctly. This can be a result of a dis-logged micro switch in the mirror assembly. Our technicians recommend checking this micro switch before replacing the mirror assembly.

3 Reports
Me Too

Verified for the Land Rover Range Rover

An oil leak may develop from the front crankshaft seal. Our technicians tell us a revised seal is available which should correct this concern.

8 Reports
Me Too

Verified for the Land Rover Range Rover

An oil leak may develop from the oil pan area. This may be caused by improper sealing of the oil pan "through" bolts. Our technicians tell use that revised "patch" bolts and sealing procedures are available to correct these leaks.

7 Reports
Me Too

Verified for the Land Rover Range Rover

A knocking type noise may be noted from the timing cover area. This may be caused by insufficient clearance between the timing cover and the end play button on the camshaft. Our technicians tell us that removing the timing cover and modifying the cam button is necessary to correct this concern.

2 Reports
Me Too

Verified for the Land Rover Range Rover

Hard starting may be noted in extreme cold conditions, -5 degrees Fahrenheit and below. Our technicians tell us an updated engine control module (ECM) PROM is available to correct this concern.

3 Reports
Me Too
Ask a Question
More about this car