Jeep Liberty Problem Reports

RepairPal Verified Jeep Liberty Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

An engine misfire at idle (rough idle), accompanied by illumination or flashing of the Check Engine Light, could indicate a problem with one or more of the intake valves. Revised intake valves & valve locks are available to address this concern.

A no crank or no start condition may develop due to electronic lockup of the wireless control module (WCM), also referred to as the Sentry Key Remote Entry Module (SKREEM). When this module fails the remote keyless entry system will also not operate. The WCM is commonly replaced to correct this concern.

If the power door locks are buzzing or are intermittently noisy, a new door latch assembly may solve this. The door lock actuators are integrated into the latch assemblies.

Certain 2002-2006 vehicles were recalled to replace the lower ball joints because they were susceptible to damage from moisture. For more information on this recall, please click here»

Leaks at the front and/or rear differential pinion seal and from the transfer case are common. Low fluid level in the differential or transfer case can result in bearing failure. Damaged bearings commonly cause a whine or growl type noise.

Broken exhaust manifold bolts can create an exhaust leak; the exhaust manifold gaskets and bolts should be replaced.

Broken exhaust manifold bolts can create an exhaust leak; the exhaust manifold gaskets and bolts should be replaced.

If previous drive belt replacements have not fixed a problem with a chirping belt, there is a service bulletin that outlines a revised drive belt routing.

The power window motor commonly fails in the front and rear doors. This may require replacement of the complete window regulator assembly which will include the window motor.

The door molding may become loose on one or both front doors. Our technicians recommend to replace the molding if this occurs.

The manual transmission may jump out of gear. Our technicians tell us that replacing the 1-2 synchronizer assembly should correct this concern.

The sky slider sunroof may develop a wind noise and/or loss of "express" mode. Our technicians tell us that lubrication the front drive cables, replacing the front header bow, and initializing the sunroof module will generally correct these concerns.

The sky slider sunroof may not open. A software upgrade for the control module is available which should correct this concern.

The remote keyless entry system (including remote vehicle start) may not work intermittently. Our technicians tell us that replacing and programing the key fobs will generally correct this concern.

The Check Engine Light may illuminate with code P1696. This fault code is for an internal powertrain control module (PCM) error. Reprogramming of the PCM will be necessary to correct this concern.