Jeep Liberty Problems
RepairPal has identified the most common problems with the Jeep Liberty based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.
A no crank or no start condition may develop due to electronic lockup of the wireless control module (WCM), also referred to as the Sentry Key Remote Entry Module (SKREEM). When this module fails the remote keyless entry system will also not operate. The WCM is commonly replaced to correct this concern.
The manual transmission may jump out of gear. Our technicians tell us that replacing the 1-2 synchronizer assembly should correct this concern.
The sky slider sunroof may not open. A software upgrade for the control module is available which should correct this concern.
If the power door locks are buzzing or are intermittently noisy, a new door latch assembly may solve this. The door lock actuators are integrated into the latch assemblies.
Leaks at the front and/or rear differential pinion seal and from the transfer case are common. Low fluid level in the differential or transfer case can result in bearing failure. Damaged bearings commonly cause a whine or growl type noise.
The door molding may become loose on one or both front doors. Our technicians recommend to replace the molding if this occurs.
The Check Engine Light may illuminate with code on or more of the following codes: P2302, P2305, P2308, P2311, P2314, P2317, P2610. Reprogramming of the PCM will be necessary to correct this concern.
The sky slider sunroof may develop a wind noise and/or loss of "express" mode. Our technicians tell us that lubrication the front drive cables, replacing the front header bow, and initializing the sunroof module will generally correct these concerns.