Isuzu Problem Reports

Most Reported Isuzu Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

One or both catalytic converters may fail resulting in illumination of the Check Engine Light. Replacement of the failed catalytic converter will be necessary to correct this condition.

On certain models contamination of the grease on the gas pedal potentiometer causes the Check Engine light (MIL) to come on and may cause a rough idle. The potentiometer will need to be replaced and adjusted to fix this problem.

The 4WD indicator may say on in 2WD mode due to a faulty vacuum solenoid or valve. All 4WD vacuum hoses, solenoids, and valves should be inspected and repaired or replaced as necessary to correct this concern.

(1) Please the check light is constantly on and when moving its not fast, moves slowly before picking.
(2) The diagnosis mention Top counter clutch fault code p2764/sharp control circuit.
(3) Shift cylinder control circuit fault code p0787.
Please can I have the part numbers for order?
Counting on your co-operation,
Thank you.

have changed the timing belt. new sparkplugs and PCM still will not fore on the left side

This problem have not fix yet. I need help!!