»

Problems for specific Hummer models:

Car problem reports

Report A Problem

Problem with your car? See what our experts say or submit your own.

Newest reported Hummer problems

 

Verified for the Hummer H3

The engine may develop a misfire due to worn valve seats. This fault will cause the Check Engine Light to illuminate. Replacement of the cylinder head may be required to correct this concern.

26 Reports
Me Too

Verified for the Hummer H2

Illumination of the Check Engine Light can be caused by a loose or worn gas cap.

11 Reports
Me Too

Verified for the Hummer H2

Illumination of the Check Engine Light can be caused by a loose or worn gas cap.

1 Report
Me Too

Verified for the Hummer H2

Illumination of the Check Engine Light can be caused by a loose or worn gas cap.

1 Report
Me Too

Verified for the Hummer H2

A Loose or worn gas cap may cause Check Engine Light to illuminate.

2 Reports
Me Too

Verified for the Hummer H3

A Loose or worn gas cap may cause Check Engine Light to illuminate.

29 Reports
Me Too

Verified for the Hummer H2

One or more heater & AC (HVAC) temperature and/or air delivery mode door actuator may fail, resulting in improper temperature or air delivery. If this occurs, fault code(s) should be stored in the HVAC control module which should assist in diagnoses.

23 Reports
Me Too

Verified for the Hummer H2

One or both secondary air injection check valves may become restricted causing poor air flow resulting in illumination of the Check Engine Light. It is often recommend to replace both check valves even if a fault code is set for only one bank of cylinders. Replacing only one valve may result in a return trip to the repair shop.

5 Reports
Me Too

Verified for the Hummer H2

A clicking noise may be noted from the turn signal flasher after the turn signals are switched off.  This is commonly cause by a faulty turn signal switch which will require replacement.

3 Reports
Me Too

Verified for the Hummer H2

A clicking noise may be noted from the turn signal flasher after the turn signals are switched off.  This is commonly cause by a faulty turn signal switch which will require replacement.

2 Reports
Me Too

Verified for the Hummer H2

The battery may leak acid at the battery cable connections. As a result corrosion may form on the battery cable ends. Leaking batteries should be replaced and the cables need to be thoroughly cleaned or replaced if necessary.

5 Reports
Me Too

Verified for the Hummer H2

The anti-lock brake system (ABS) pump may stay running after the ignition is turned off causing the battery to go dead. Our technicians tell us that the ABS control module should be replaced to correct this fault.

5 Reports
Me Too

Reported by garyj0nes and 1 other for the Hummer H3

I was in Death Valley, CA off roading. Nothing too major. The second day we were traveling down a gravel road when BANG! The side airbags on both sides of the car deployed. I have it in the shop right now and awaiting response.

2 Reports
Me Too

Verified for the Hummer H2

Units with 4 wheel disk brakes may develop at situation where the park brake does not hold as it should. Our technicians tell us this can be caused by worn park brake shoes located inside the drum section of the rear brake disks. The worn shoes should be replaced and properly adjusted to correct this issue.

5 Reports
Me Too

Verified for the Hummer H2

The CD player may fail due to an internal fault with the radio. Our technicians tell us that in most cases, the radio unit will need to be sent to a specialty repair shop to correct this issue.

8 Reports
Me Too
Ask a Question
More about this car