Honda Accord Problem Reports

RepairPal Verified Honda Accord Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

A Check Engine Light may illuminate if the EGR ports have clogged or if the catalyst inside the catalytic converter has deteriorated.

A faulty brake master cylinder reservoir filter can cause the brake system indicator to illuminate after a cold start and then go off. Replacement of the reservoir filter will commonly fix this problem.

Excessive oil consumption can cause a low oil level condition, which can result in illumination of the Check Engine Light.

The front brake rotors can warp and cause a vibration when braking. The rotors will need to be machined or in cases where they are worn to thin, replaced to correct this issue.

Some models with the manual transmission can grind while shifting up into fifth gear due to the misalignment of the fifth gear shift fork. The transmission will need to be removed, and fifth gear, the synchronizer sleeve set, and the fifth gear shift fork will need to be replaced.

A rough idle and harsh transmission shift can be caused by a broken front engine mount. Replacing the broken mount will address these issues.

The head gaskets are prone to fail if the engine overheats. When the temperature climbs above the normal operating temperature, turn the heater on the hottest setting, pull over, and shut the engine off to allow the engine to cool down.

The moon roof may not close all the way because of a faulty limit switch. The headliner must be removed to replace the limit switch.

If the idle is higher than normal when the engine is cold and the Check Engine Light is on, the powertrain control module (PCM) may need a software update to fix the concern.

Automatic transmission failures are common, Automatic transmission failure on these vehicles will generally require overhaul or replacement of the transmission. In the event of a  failure, it may be worthwhile to check with Honda to see if they may offer assistance for this repair. As these vehicles age, Honda has become less likely to help out with these transmission related repairs.

Head gasket failure is not uncommon if the engine overheats. If the temperature climbs above the normal operating temperature, turn the heater on the hottest setting, pull over to a safe location, and shut the engine off to allow the engine to cool down.

One or both of the rear sway bar end links may break resulting in a knocking noise from the rear of the vehicle.

The ABS modulator (hydraulic unit) can leak air into the brake system and cause a low brake pedal. A new ABS modulator will be needed if it is diagnosed to be the source of the leak.

Ignition switch failure may cause the car to stall or fail to start. Honda issued a recall to replace the ignition switch. For more information on this recall please click here»

A chirping noise coming from the timing belt area can be caused by a misaligned, or tilted idler pulley.