Engine hesitated while accelerating from a stop. The check engine light (CEL) came on immediately. Autozone pulled the code of P2647. I replaced the oil pressure switch (37250-PNE-G01) and the o-ring (91319-PAA-A01).
Problems for specific Honda Accord years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported Honda Accord problems
Damaged engine mounts can lead to vibration and roughness felt in the steering wheel. A rattle in the dash and engine area may also be heard. Replacement of damaged mounts will commonly correct these issues.
The driver's door latch assembly can break internally, which causes the door to stay closed. The interior and exterior door handles do not work to open the door. Our technicians note that the door panel must be removed while the door is closed (likely damage will occur) and the latch assembly must be drilled in a specific spot for the door to open.
Power door locks can activate intermittently due to a faulty door lock actuator in the driver's door.
The temperature control knob may break, requiring replacement.
Leaking gaskets around the tail lights can allow water entry into the tail light assembly. New gaskets should fix this concern.
The radio and climate control display can go dark on some models. It will be necessary to replace the affected unit to correct this concern. Some customers have reported receiving help from Honda regarding this repair.
There is considerable tread wear on the outer and inner areas of both front tires. The wear leaves jagged edges on the tire surface and does not happen to the rear tires. My local tire technician suggests that the wheel bearings may require replacement. I havent taken it to my honda dealer yet because i'm abroad. Please advise on the solution. vehicle mileage is 14340 miles
Some models have shift quality problems when shifting into third gear. A new "third gear set" from Honda will address this issue.
An oil leak inside the distributor can cause the engine to misfire resulting in a loss of power. It is common for the distributor to be replaced to correct this concern.