Honda Accord Problem Reports

Newest Honda Accord Problem Reports

Report A Problem

The ABS modulator valve assembly (hydraulic unit) may develop a brake fluid leak.  This can result in illumination of the ABS warning light and in certain cases, loss of braking ability.

 

The ABS modulator valve assembly (hydraulic unit) may develop a brake fluid leak.  This can result in illumination of the ABS warning light and in certain cases, loss of braking ability.

If the brake pedal feels hard the first time it is pressed in the morning, it could be due to a problem with the vacuum supply hose for the brake booster. A revised brake booster hose is available to address this concern.

The balance shaft seal tends to fall out causing a large oil leak. There is a retaining device available to prevent the seal from falling out, which can be put in place during routine timing belt maintenance.

Occasionally, the anti-lock brake (ABS) warning light may illuminate. This could be due to a faulty rear wheel speed sensor. The sensor design has been updated and revised parts are available to correct this problem.

 

The AC evaporator and/or the AC condenser can develop a refrigerant leak. The AC system will not blow cold air if this happens. Diagnoses, commonly using leak detection dye will be necessary to determine the source of the leak.

The AC evaporator can develop a refrigerant leak. The AC system will not blow cold air if this happens.

Plugged moon roof drains can cause a water leak inside the car. The water will usually leak onto the driver's or passenger's head when the car turns a corner.

Some models have problems with alternator bearing failures.

On some models a mis-manufactured AC evaporator core can cause the AC to cool poorly. The AC evaporator needs to be replaced for the AC to cool properly.

Accords powered by the V6 engine had a defective timing belt tensioner that could result in excess "slack" in the timing belt. This could cause premature timing belt failure, which could result in serious engine damage.

The clock light has a tendency to burn out.

A faulty gasket can cause coolant seepage from the water passage near the exhaust gas recirculation (EGR) valve. Replacing the gasket should correct this coolant leak.

A water leak on the passenger floor can be caused by a clogged AC evaporator drain.