GMC Sonoma Problem Reports

Newest GMC Sonoma Problem Reports

Report A Problem

The spark plug wire rubber boots may get soaked with oil, causing a misfire or rough idle.

The distributor may develop internal faults. This can cause a rough running engine or stalling condition and the Check Engine Light may or may not illuminate. The distributor should be overhauled or replaced to correct this concern.

The distributor may develop internal faults. This can cause a rough running engine or stalling condition, the Check Engine Light may or may not illuminate. Our technicians tell us that the distributor should be overhauled or replaced to correct this concern.

The distributor may develop internal faults. This can cause a rough running engine or stalling condition, the Check Engine Light may or may not illuminate. Our technicians tell us that the distributor should be overhauled or replaced to correct this concern.

A Loose or worn gas cap may cause Check Engine Light to illuminate.

The EGR valve may stick open causing a rough idle and the Check Engine Light light to illuminate. Our technicians tell us that a piece of carbon may become stuck in the valve causing this problem. Cleaning the valve will usually correct this condition, in some rare cases the valve will need to be replaced.

The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Running the engine with a coolant/oil mix may result in engine damage. Replacing the intake manifold gasket should correct this issue.

The serpentine belt tensioner can fail; it may become noisy and/or the belt may jump off. Replacement of the failed tensioner will be necessary.

The oxygen sensor can fail causing Check Engine Light illumination and the engine to run rich (burn more fuel than normal).

Vehicles equipped whit a 4 speed automatic transmission may develop a harsh 1-2 shift and/or illumination of the Check Engine Light with code P1870 stored. This can be caused by wear of the bore for the TCC isolator and regulator valves in the valve body. This condition does not commonly occur until the transmission reaches normal operating temperature. If the valve body is worn, replacement will be necessary to correct this concern.

Vehicles using the enhanced vortec V6 engine may be hard to start run poorly and/or use to much fuel due to a fuel leak inside the intake manifold plenum. Commonly this is caused by a leaking fuel pressure regulator or fuel line. The fuel system will need to be pressurized with the upper intake manifold removed in order to determine the exact cause of the leak. Removing the "tuning valve" from the upper intake can allow for limited visual inspection without removing the upper intake manifold.

The HVAC blower motor may stop working at one or more speeds due to a faulty blower motor resistor block. Our technicians recommend to confirm the resistor is at fault by first checking the operation of the switch.

A door window may move slowly or stop in mid travel due to a failing power window motor. The affected window may start working again after the motor cools off. Replacing the faulty window motor will commonly correct this concern.

An engine oil leak may develop from the distributor shaft o-ring seal.

A fluid leak may develop from the transmission output shaft seal. This leak may cause the transmission mount to become oil soaked and require replacement of the mount along with the leak repair.