Ford Problem Reports

RepairPal Verified Ford Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

If a noise from the rear end is heard when going around turns or after driving at highway speed for an extended period, this could be caused by a failing deferential clutch kit. An updated differential clutch kit available.

If a noise from the rear end is heard when going around turns or after driving at highway speed for an extended period, this could be caused by a failing deferential clutch kit. An updated differential clutch kit available.

The synchronizer shaft for the camshaft position sensor can cause a loud squeak or chirping noise due to failure of the upper bushing. The noise may be erratic and is usually present when the engine is warm.

The synchronizer shaft for the camshaft position sensor can cause a loud squeak or chirping noise due to failure of the upper bushing. The noise may be erratic and is usually present when the engine is warm.

The synchronizer shaft for the camshaft position sensor can cause a loud squeak or chirping noise due to failure of the upper bushing. The noise may be erratic and is usually present when the engine is warm.

The synchronizer shaft for the camshaft position sensor can cause a loud squeak or chirping noise due to failure of the upper bushing. The noise may be erratic and is usually present when the engine is warm.

The intake manifold O-ring gaskets commonly leak, causing stalling and poor idle quality; the Check Engine Light will illuminate.

The intake manifold O-ring gaskets commonly leak, causing stalling and poor idle quality; the Check Engine Light will illuminate.

A defective driveshaft can cause a drone to be heard from the driveline area. The driveshaft should be replaced with a revised unit.

A defective driveshaft can cause a drone to be heard from the driveline area. The driveshaft should be replaced with a revised unit.

If the slip yoke in the driveshaft is binding, it can make a clunking noise when pulling away from a stop. The slip yoke will need to be lubricated.

If the slip yoke in the driveshaft is binding, it can make a clunking noise when pulling away from a stop. The slip yoke will need to be lubricated.

If the slip yoke in the driveshaft is binding, it can make a clunking noise when pulling away from a stop. The slip yoke will need to be lubricated.

If there is a vibration or noise at highway speed, it could be from the frontdrive shaft and may require replacement of the double cardan joint. A double cardan joint is a type of driveshaft joint that uses two universal joints.

If there is a vibration or noise at highway speed, it could be from the front driveshaft and may require replacement of the double cardan joint. A double cardan joint is a type of driveshaft joint that uses two universal joints.