Ford Ranger Problem Reports

Newest Ford Ranger Problem Reports

Report A Problem

A rattling noise from the engine may indicate that the timing chain cassette is worn. Our technicians tell us that installing an updated cassette and timing chain tensioner should correct this concern.

The engine may misfire and/or buck while driving at freeway speeds with no fault code stored in the powertrain control module (PCM). This can be caused by an intermittent fault with the camshaft synchronizer assembly. This condition can be diagnosed by monitoring knock sensor data as per Ford service bulletin #05-22-12. Replacement of the synchronizer assembly will be required to correct this concern.

If you experience cold starting problems, stalling at idle, or hesitations during acceleration, it may be the idle air bypass valve. This valve helps the vehicle idle steadily and run when the accelerator pedal is not pressed.

If a noise from the rear end is heard when going around turns or after driving at highway speed for an extended period, this could be caused by a failing deferential clutch kit. An updated differential clutch kit available.

If a noise from the rear end is heard when going around turns or after driving at highway speed for an extended period, this could be caused by a failing deferential clutch kit. An updated differential clutch kit available.

The synchronizer shaft for the camshaft position sensor can cause a loud squeak or chirping noise due to failure of the upper bushing. The noise may be erratic and is usually present when the engine is warm.

it seems to bog down when u press on the accelerator if u go slow i mean real slow it does ok also seems to bog down when it reaches 3k rpm like its starving for fuel or getting too much

The front brakes may stick, bind, or grab. This can happen when the front brake caliper pins become corroded. Cleaning or replacing the caliper pins will be necessary to correct this problem.

The magnet for the camshaft position sensor may fall out of its mount and damage the synchronizers. This causes long crank times when starting the engine and may cause the Check Engine Light to illuminate. If this happens, both the magnets and the synchronizers need to be replaced.

The magnet for the camshaft position sensor may fall out of its mount and damage the synchronizers. This causes long crank times when starting the engine and may cause the Check Engine Light to illuminate. If this happens, both the magnets and the synchronizers need to be replaced.

If you experience difficulty starting the engine when cold, stalling at idle, or hesitations during acceleration, it may be the idle air bypass valve. This valve helps the vehicle idle steady when the accelerator pedal is not pressed.

Noisy engagement of clutch slave cylinder to the pressure plate can cause a squeak noise when pressing and releasing the clutch. Replacement of the clutch disc, pressure plate, clutch slave cylinder, plus the application of a special metal assembly paste to the mating components will be needed to reduce the noise.

The battery light may illuminate on the instrument panel because the alternator wire harness connector is damaged. A new connector kit is available and should be installed to correct this concern.

A buzzing type noise may be noted from upper engine area at about 1900 RPM, under light acceleration. Our technicians tell us this can be caused by loose ignition coil bracket bolts. Coil bracket bolts should be checked for the correct torque before further diagnoses is performed.

The engine may have a higher that normal idle at times. After cold start with an automatic transmission and when the clutch is depressed with a manual transmission. Our technicians tell us updated powertrain control module (PCM) software is available to address this concern.