Ford Crown Victoria Problem Reports

Newest Ford Crown Victoria Problem Reports

Report A Problem

The illumination of the Check Engine Light is common due to ignition misfire, often caused by bad spark plugs or ignition coil.

check wires in visor for visor lights,will chafe and short to ground over time and blow fuse. tape or heat shrink exposed wire to solve problem.

Hooting, moaning sound similar to ship's horn or foghorn coming from engine. Sound initially only happens for brief periods during warm up, but then occurs during driveaway & while idling at red lights, stop signs, etc. Sound originates from the IAC Tube that connects the Idle Air Control Valve to the air intake tube. Fix is addressed in Ford Article 94-22-4. Problem is the factory IAC Tube. Original tube needs to be replaced with a re-en...

Severe oil leak causing the need to add up to one or more quarts of oil every couple of days. The oil leaks most when engine is off. The longer the car sets, the more the oil leaks, until it is all gone. Caused by extreme severe corrosion of oil pan. The corrosion is 'flaky' and pieces of the pan come off in layers. Oil seeps right thru the corrosion. The only solution is to have oil pan replaced, which is a major repair.

One or more oxygen sensors may fail resulting in illumination of the Check Engine Light.

Starter failed on my 2001 crown victoria, Dec' 2011. Car would produce one loud click (the pinion bearing coming out), but not turn over. After several attempts it would eventually turn over. Battery is six years old so it's not putting out as well as it use to... Pulled the starter out (3 bolts, what a PAIN.. hint: use a 1/4" socket wrench for the top bolt!) and tested with just battery, same problem. Had it tested at the auto parts store...

A spring in the seat belt buckle may wear or fail, causing the airbag light on the instrument panel to illuminate. Failed buckles will require replacement.

The EGR valve position (EVP) sensor can fail on this vehicle. The EVP sensor measures the EGR valve position and transmits the date to the engine control computer. If it fails, drivability and fuel economy can suffer, the Check Engine Light will commonly illuminate.

It is not uncommon for the intake manifold and/or valve cover gaskets to develop a coolant or oil leak. Leakage from the intake manifold may result in coolant in the engine oil. Coolant mixing with the engine oil severally impacts the lubrication ability of the oil. Internal engine may result if this condition is not repaired promptly.

Transmission problems are common in this model, often as a result of a failed front pump. The pump loses its ability to create hydraulic pressure, which an automatic transmission needs to function. A sign of front pump failure can be a whine type noise.

The steering gear may have an internal problem that makes turning to one side difficult; it may need to be replaced. A wheel alignment is needed after the steering gear is replaced.

The engine may overheat at idle when the AC is on. A new, upgraded fan motor and resistor assembly should be installed.

The composite (plastic) intake manifold may crack near the thermostat housing and cause a coolant leak. Ford released an updated manifold that was reinforced to prevent a recurrence. No recall was issued for this problem but Ford did extend the warranty to seven years on some models from the date of purchase.

The throttle position sensor (TPS) may fail. Common symptoms of a defective TPS can be rough idle, hard starting, hesitation on acceleration, poor fuel economy, and stalling.

The throttle position sensor (TPS) may fail. Common symptoms of a defective TPS can be rough idle, hard starting, hesitation on acceleration, poor fuel economy, and stalling.