On the 3.9L V6 and 5.2L V8, rerouting the ignition coil wire and spark plug wires can help solve a misfire and/or surge problem that occurs at approximately 45 mph. A service bulletin was published that outlines the specifics of the repair. It states the rerouting procedure should be performed before other repairs are done for misfires, surging or spark knock.
Problems for specific Dodge Ram 3500 years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Repairpal verified Dodge Ram 3500 problems
Replacing a pressure solenoid valve in the transmission valve body may fix an issue where the transmission "hunts" between first and second gears. Our technicians report that customers sometimes describe this complaint as surging or bucking.
A surging or bucking during acceleration can be caused if the distributor is moved or mis-indexed. This is a result of the cam and crank position sensors being out of synchronization. Wear of the oil pump drive gear can cause similar symptoms because it allows excessive free play in the distributor drive. The distributor drive gear and bushing should be replaced if the rotor tip moves back-and-forth more than 3/16th of an inch when checking drive gear free play.
If the transmission delays initial gear engagement after being parked overnight or longer, it may be due to a suspect transmission cooler return filter. If the transmission was recently serviced and the part number for the cooler return filter contains an "AB" suffix at the end, a new filter should be installed.
The AC/heater (HVAC) system may unexpectedly switch to the defrost mode when accelerating. This system is operated by engine vacuum and should be inspected for any vacuum leaks if this problem develops. There is also a revised vacuum check valve available to address this concern.
If a clunking or "loose lumber" noise is coming from the front or rear suspension, there are revised shock absorbers available that can help the concern. This is usually heard at lower speeds and colder temperatures when driving over bumps.
The track for the power seat may need to be replaced if the seat rocks when the vehicle accelerates or slows down.
Engine overheating can result from coolant leaks which are commonly found at the thermostat housing gasket, water pump, heater return tube O-ring at the water pump, intake manifold gasket, and timing cover gasket. Our technicians recommend a complete inspection of the cooling system after any repairs are made to be sure there are no other leaks.
The intake manifold gaskets may leak. Coolant loss may be noticed as coolant leaks into the engine oil and/or there may be a rough idle or whistling noise. The intake gaskets need to be replaced if they are leaking coolant internally to prevent engine damage.
If the engine cranks but does not start, or starts and stalls, the fuses should be inspected, especially the power door locks fuse. The power door lock fuse provides power to a module that sends the Powertrain Control Module (PCM) the "OK to start" signal.
On 3.9L V6 and 5.9L V8 engines, the intake manifold gasket may leak and cause increased oil consumption and a spark knock during acceleration; the gasket should be replaced.
If the engine is difficult to start or cranks but does not start, it can be caused by a leak in the return side of the fuel system. This type of leak can allow air to enter the injection pump resulting in starting issues. A rubber hose on the back of the injection pump, connecting the pump to the steel hard line, that can be the source of this type of leak.