On the 3.9L V6 and 5.2L V8, rerouting the ignition coil wire and spark plug wires can help solve a misfire and/or surge problem that occurs at approximately 45 mph. A service bulletin was published that outlines the specifics of the repair. It states the rerouting procedure should be performed before other repairs are done for misfires, surging or spark knock.
Problems for specific Dodge Ram 2500 years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported Dodge Ram 2500 problems
A surging or bucking during acceleration can be caused if the distributor is moved or mis-indexed. This is a result of the cam and crank position sensors being out of synchronization. Wear of the oil pump drive gear can cause similar symptoms because it allows excessive free play in the distributor drive. The distributor drive gear and bushing should be replaced if the rotor tip moves back-and-forth more than 3/16th of an inch when checking drive gear free play.
If the transmission delays initial gear engagement after being parked overnight or longer, it may be due to a suspect transmission cooler return filter. If the transmission was recently serviced and the part number for the cooler return filter contains an "AB" suffix at the end, a new filter should be installed.
When switching on a turn signal, both lights flash or nothing happens. Wipers fail or work sporadically. There are on back order 4,000 of the parts required to fix this problem. I wish more people would report these problems to www.nhtsa.gov so that recalls can take place.
The AC/heater (HVAC) system may unexpectedly switch to the defrost mode when accelerating. This system is operated by engine vacuum and should be inspected for any vacuum leaks if this problem develops. There is also a revised vacuum check valve available to address this concern.
If a clunking or "loose lumber" noise is coming from the front or rear suspension, there are revised shock absorbers available that can help the concern. This is usually heard at lower speeds and colder temperatures when driving over bumps.
The track for the power seat may need to be replaced if the seat rocks when the vehicle accelerates or slows down.
The intake manifold gaskets may leak. Coolant loss may be noticed as coolant leaks into the engine oil and/or there may be a rough idle or whistling noise. The intake gaskets need to be replaced if they are leaking coolant internally to prevent engine damage.
If the engine cranks but does not start, or starts and stalls, the fuses should be inspected, especially the power door locks fuse. The power door lock fuse provides power to a module that sends the Powertrain Control Module (PCM) the "OK to start" signal.
On 3.9L V6 and 5.9L V8 engines, the intake manifold gasket may leak and cause increased oil consumption and a spark knock during acceleration; the gasket should be replaced.
If the engine is difficult to start or cranks but does not start, it can be caused by a leak in the return side of the fuel system. This type of leak can allow air to enter the injection pump resulting in starting issues. A rubber hose on the back of the injection pump, connecting the pump to the steel hard line, that can be the source of this type of leak.