Chrysler Town & Country Problem Reports

Newest Chrysler Town & Country Problem Reports

Report A Problem

An oil leak from the oil filter adapter may be evident. Chrysler has made a revised oil filter adapter is available.

The rear lift gate support (prop) attaching bolts may break, causing the lift gate to fall unexpectedly. Thorough inspection of the bolts is required; if the support washers are loose, the supports need to be replaced.

One or more power windows may stop working due to a failed regulator or motor which will require replacement. Our technicians tell us the regulator and motor is replaced as a set on these vehicles.

One or more power windows may stop working due to a failed regulator or motor which will require replacement. Our technicians tell us the regulator and motor is replaced as a set on these vehicles.

A defective vehicle speed sensor can cause problems with the cruise control and speedometer operation, as well as erratic shifting. The connectors on the sensors are also susceptible to corrosion, which will create similar symptoms. Any of these problems can cause Check Engine Light illumination.

Excessive oil consumption—defined as more than one quart per 1,000 miles (on vehicles with less than 50,000 miles) or more than one quart per 750 miles (on vehicles with more than 50,000 miles)—is common. Common causes include exhaust valve guides, valve cover gaskets, camshaft plugs, camshaft seals, and crankshaft seal.

The Check Engine Light may illuminate for many different reasons, some of which may be corrected by updating the software in the powertrain control module (PCM).

A moaning or fog horn sound may be heard while turning at a slow speed. Installing a finned power steering cooler will help alleviate the problem, but it may be necessary to replace the power steering rack.

If you hear a popping, clunking, or snapping sound from the front of the vehicle after five miles of driving on smooth surfaces, the outer tie rod ends may be worn and require replacement.

If you hear a popping, clunking, or snapping sound from the front of the vehicle after five miles of driving on smooth surfaces, the outer tie rod ends may be worn and require replacement.

Misalignment of the accessory pulleys or a faulty drive belt tensioner may cause a chirping or squeaking sound while the engine is running. In If the replacing the belt tensioner does not correct the noise, the alternator pulley may require replacement.

Defective speed sensors on the transmission can cause problems with the cruise control and speedometer operation, as well as erratic shifting. The connectors on the sensors can corrode and/or the connector terminals can spread (poor connection), which will create similar symptoms. Any of these problems can cause Check Engine Light illumination.

 

Intermittently, the key may not start the car or release from the ignition. If it is excessively worn, replace the key. If the new key doesn't work, replacing the lock cylinder including tumblers should correct this concern.

If the door lock actuators (integrated into the door latch assembly) are noisy and/or not working, the latch should be replaced. For some model years, the actuator for the sliding door is available separately from the latch.

Coolant leaks coming from the underbody on vehicles equipped with rear heat/AC are common. The underbody hoses should be inspected as part of regular maintenance. If you drive on roads where salt is prevalent the problem is generally more severe. Some 2005 models are involved in a special service action, no government recall was issued.