Chevrolet Tahoe Problem Reports

Newest Chevrolet Tahoe Problem Reports

Report A Problem

The alternator may fail causing the battery to go dead, or an abnormal noise may develop. The dash warning light may or may not illuminate. A failed alternator will require replacement.

The 4WD transfer case encoder motor position sensor or the selector switch may fail causing the service 4WD message to be displayed. Fault code(s) stored in the transfer case control module will be of assistance in determining the exact fault causing the message to be displayed.

Vehicles equipped whit a 4 speed automatic transmission may develop a harsh 1-2 shift and/or illumination of the Check Engine Light with code P1870 stored. This can be caused by wear of the bore for the TCC isolator and regulator valves in the valve body. This condition does not commonly occur until the transmission reaches normal operating temperature. If the valve body is worn, replacement will be necessary to correct this concern.

Power brake systems using "hydro-boost" may leak power steering fluid from the hydro-boost unit located behind the brake master cylinder. Replacement of the hydro-boost unit is the common repair to correct this concern.

A rattling noise may develop from the AC belt tensioner. This can be caused by an internal fault with the AC compressor, AC performance may also be diminished when this occurs. Our technicians tell us that replacing the AC compressor will commonly correct this concern.

 

One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.

One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.

One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.

One or both secondary air injection check valves may become restricted causing poor air flow resulting in illumination of the Check Engine Light. It is often recommend to replace both check valves even if a fault code is set for only one bank of cylinders. Replacing only one valve may result in a return trip to the repair shop.

A clicking noise may be noted from the turn signal flasher after the turn signals are switched off.  This is commonly cause by a faulty turn signal switch which will require replacement.

The upper dash may crack, most commonly on vehicles in warm climates and exposed to a lot of sunlight. The common repair is to replace the upper instrument trim panel. Information on a technical service bulletin or extended warranty is not available at this time.

The quick-connect fittings for the heater hoses tend to leak engine coolant. This problem commonly occurs because the metal housing has become brittle, which can break and cause leaks.

The air conditioning compressor may develop an abnormal noise and require replacement. We recommend that whenever an AC compressor is being replaced for a noise condition, a filter kit should be installed to prevent any metal particles in the system from damaging the new compressor.

Acid may leak from the battery at the cable connections, resulting in corrosion on the battery cable ends and in the battery tray. A Leaking battery should be replaced and the cables thoroughly cleaned or replaced if necessary.

The daytime running lights are prone to burning out. Our technicians tell us that the light sockets may show signs of heat damage but usually are OK. Always be sure to use the correct replacement bulb for the best life expectancy. The new bulb recommendation for 2000-2003 models is #4114K (trade number).