Chevrolet Suburban 1500 Problem Reports

Newest Chevrolet Suburban 1500 Problem Reports

Report A Problem

One or more fuel injectors may become stuck closed causing an engine misfire  and the Check Engine Light to illuminate. Our technicians tell us that this problem can be caused by some fuel additives. There are special procedures which may be able to restore the affected injector. If this fails the affected injector must be replaced.

Noticed white colored goo on oil dipstick during oil addition. Dealer indicated a failed head gasket. Solution is to replace the head gasket. Will also replace the valve cover which the dealer indicates is now a better design than the original cover. Dealer estimate is approx. $1200.

The intake manifold gasket may develop an external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Running the engine with a coolant/oil mix may result in engine damage. Replacing the intake manifold gasket should correct this issue.

I can't believe that the 07 Suburban oil consumption problem hasn't been mentioned on this site, it is everywhere else. Many 07 Suburbans burn a lot of oil - GM will try to tell you that a quart every 1500 - 2000 is normal - which is just ridiculous. If you burn a quart every 1000 as mine did they will repair it (if you are under 100,000 miles). It's a big repair, major engine rebuild. In mine, there was a lot of valve train damage, so it'...

The distributor may develop internal faults. This can cause a rough running engine or stalling condition, the Check Engine Light may or may not illuminate. Our technicians tell us that the distributor should be overhauled or replaced to correct this concern.

The engine may develop a misfire due to worn valve seats. This fault will cause the Check Engine Light to illuminate. Our technicians tell us the misfire may or may not be felt while driving. They further recommend that both cylinder heads be removed and thoroughly inspected and repaired as necessary.

Illumination of the Check Engine Light can be caused by a loose or worn gas cap.

Illumination of the Check Engine Light can be caused by a loose or worn gas cap.

A Loose or worn gas cap may cause Check Engine Light to illuminate.

The front or rear differential may develop an abnormal noise due to worn bearings or another internal fault. Our technicians tell us that a complete overhaul of the affected differential is commonly necessary to correct this condition.

The inside door handles are prone to breaking.

The keyless entry system may stop working. Our technicians tell us the key fobs and keyless entry receiver may need to be replaced to correct this fault.

The alternator may fail causing the battery to go dead, or an abnormal noise may develop. The dash warning light may or may not illuminate. A failed alternator will require replacement.

Had to replace due to excess wear. Suburban not driven hard - these failed prematurely. In addition, repair by replacing just ball joints made 3 times more expensive due to GM design. The upper control arms had to be replaced making the parts very expensive and the labor 3 times more than normal.

The valve cover gaskets may develop engine oil leaks.