2009 chevy Malibu suddenly disabled unable to shift into reverse towed to dealer broken wave plate transmission had to be rebuilt....
Chevrolet Malibu Problem Reports
Newest Chevrolet Malibu Problem Reports
The ignition switch may fail causing a no start condition. This is not generally a theft system (passlock) issue because the security light does not illuminate or flash.
3 no starts in 2 weeks. First 2 times said security and made me buy new key. 3rd ubec
, relay and wire harness melted. 3 months later no start not getting fuel. If they would recall ignition switch and security system everyone complain nhtsa site
The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Our technicians tell us that operating the engine with a coolant/oil mix can result in internal engine damage. Replacing the intake manifold gasket should correct these leaks.
The fuel gauge may not read correctly and/or the Check Engine Light may illuminate with code P0455/P0461 stored for a fuel level sensor issue. These faults may be caused by a fuel vapor line inside the fuel take interfering with the fuel level sensor. If this is found to be the case, repositioned and securing the vapor line should correct this concern. If no fault is found with the fuel vapor line, the fuel level sensor itself may be at fault.
Transmission Fault and/or Check Engine Light With Code P0716, P0776, P0717, P0777, P2714, P2715, and/or P02723
Vehicles with a 6speed automatic transmission may develop one or more of the following faults related to a broken 35R clutch wave plate inside the transmission: Illumination of the Check Engine Light with code P0716, P0776, P0717, P0777, P2714, P2715, and/or P02723, loss of reverse gear, slipping or harsh 3rd or 5th gear shift. Removal and dis-assembly of the transmission will be required to replace the broken 35R wave plate. It is also extremely important that all debris from the failed part be cleaned from the transmission while it is disassembled in order to try and prevent future problems.
Illumination of the Check Engine Light can be caused by a loose or worn gas cap.
The instrument panel and switch backlighting may fail due to a faulty dimmer control module. A failed module will require replacement.
Corrosion may develop at the connection between the ignition coil tower and spark plug wire resulting in an engine misfire. The Ignition coil and spark plug wire should both be replaced to correct this condition.
An engine oil leak may develop from the rear of the engine. This is commonly caused by a failed oil pump drive o-ring seal. The leaking o-ring should be replaced to correct this concern.
It is common for the high pressure power steering rubber hoses to leak. Our technicians recommend replacing leaky rubber hoses to prevent the loss of power steering.