Chevrolet Corvette Problem Reports

Newest Chevrolet Corvette Problem Reports

Report A Problem

installed fuel pump and fuel filter vette had been idle for 10 years in garage

An internal distributor fault could cause the Check Engine Light to illuminate, an engine misfire, or a stalling condition. Replacement of the distributor is commonly recommend to correct this concern.

Illumination of the Check Engine Light may be the result of a loose or worn gas cap.

A loose or worn gas cap could be cause the Check Engine Light to illuminate.

A loose or worn gas cap could be cause the Check Engine Light to illuminate.

The service steering column lock message may be displayed, the engine may start and stall when put into gear. Our technicians tell us that this fault is related to the anti-theft system and the steering column lock system must be repaired as necessary. Certain models were recalled for this issue. For more information on this recall please click here»

The intake manifold gasket can develop external engine oil leaks. The intake manifold will need to be removed and the gaskets replaced to correct this issue.

The transmission may develop a harsh 1-2 shift and/or illumination of the Check Engine Light with code P1870 stored. This can be caused by wear of the bore for the TCC isolator and regulator valves in the valve body. This condition does not commonly occur until the transmission reaches normal operating temperature. If the valve body is worn, replacement will be necessary to correct this concern.

One or both secondary air injection check valves may become restricted causing poor air flow resulting in illumination of the Check Engine Light. It is often recommend to replace both check valves even if a fault code is set for only one bank of cylinders. Replacing only one valve may result in a return trip to the repair shop.

A coolant leak may develop from the water pump. The engine may overheat as a result of the coolant loss. A leaking water pump should be replaced.

Problems with anti-theft systems using the raised-chip key can prevent the car from starting. The wires in the steering column to the ignition lock cylinder tend to break. The key and ignition lock cylinder should be replaced to correct this condition.

A dirty throttle body may cause a lower than normal idle and possible stalling condition. Performing a throttle body service will commonly correct this concern.

It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.

The fuel pump can fail causing the engine to stall and not restart. Our technicians highly recommend to replace your fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.

The steering wheel position sensor may fail, resulting in the service stability message being displayed.