Chevrolet Celebrity Problem Reports

Newest Chevrolet Celebrity Problem Reports

Report A Problem

The ignition module or crankshaft position sensor may fail causing the engine to die and not restart. Diagnoses will be necessary to determine if the module or crank sensor is causing the no start condition.

The spark plug wire rubber boots may get soaked with oil, causing a misfire or rough idle.

The steering rack may fail causing the steering to become hard to turn.

The inside door handle may break causing the door not to open from the inside.

The outer tie rod ends on the steering linkage may wear causing excessive free play in the steering and uneven tire wear. If the worn tie rod ends are replaced, the wheel alignment should be checked and adjusted as necessary.

A stalling issue may occur if the battery goes dead or is disconnected and the "idle learn" procedure is not performed. For more information on "relearning" the engine idle speed, please click here»

The oxygen sensor can fail causing the engine to run very rich or use more gasoline than normal. Black smoke may be emitted from the tail pipe and this can also accelerate failure of the catalytic converter.

The upper intake manifold gasket and/or a PCV vacuum lines/hoses can develop vacuum leaks with age. This type of leak can result in a higher that normal or rough idle.

A coolant leak and/or engine overheating may be caused by a failed water pump. Replacement of the leaking pump should correct this concern.

The torque converter clutch can stick "on" after extended freeway driving causing the engine to stall when coming to a stop. Our technicians tell us when this occurs, the engine usually will restart and stall when put into gear. After allowing about twenty minutes for the engine and transmission to cool down, the engine will start and the transmission will operate normally. Replacing the torque converter clutch solenoid, transmission filter, and fluid will generally correct this issue.

Front brake rotors can wear causing a pulsation felt in the brake pedal. Our technicians tell us this condition is best corrected by replacement of the front rotors and brake pads.

The fuel pump may fail causing engine to stall and not restart.

The rubber section of an automatic transmission cooler line may develop a fluid leak . In some cases the leaking section of hose can be replaced. In others, the complete cooler line must be replaced to correct this concern.

Body: A dirty throttle body may cause a lower than normal engine idle resulting in a stalling condition. A stalling condition may also result if an idle learn procedure is not performed if the battery goes dead or is disconnected.