Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported Chevrolet Beretta problems
The steering rack may develop a fluid leak or fail causing the steering to become hard to turn.
A Loose or worn gas cap may cause Check Engine Light to illuminate.
The serpentine belt tensioner can fail; it may become noisy and/or the belt may jump off. Replacement of the failed tensioner will be necessary.
The engine vacuum hose to the MAP sensor may crack resulting in a vacuum leak causing the engine to run rough and/or stall.
One or more of the fuel injectors may short out electrically causing a rough idle condition.
The PCV vacuum hose under the upper intake plenum may become brittle and crack causing an engine vacuum leak.
The torque converter clutch can stick "on" after extended freeway driving causing the engine to stall when coming to a stop. Our technicians tell us when this occurs, the engine usually will restart and stall when put into gear. After allowing about twenty minutes for the engine and transmission to cool down, the engine will start and the transmission will operate normally. Replacing the torque converter clutch solenoid, transmission filter, and fluid will generally correct this issue.
The timing chain tensioner and guides are prone to wear and may develop an abnormal noise, requiring replacement.
A coolant leak may develop from the water pump. This can result in an engine overheating condition. A leaking water pump will require replacement.
An automatic transmission fluid leak may develop from the rubber section of a transmission cooler line. In some cases the rubber section of hose can be replaced. In others, the complete cooler line must be replaced to correct this type of leak.