Chevrolet Beretta Problems

RepairPal has identified the most common problems with the Chevrolet Beretta as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
×
Choose your vehicle
20
Known Problems

The engine vacuum hose to the MAP sensor may crack resulting in a vacuum leak causing the engine to run rough and/or stall.

A Loose or worn gas cap may cause Check Engine Light to illuminate.

The serpentine belt tensioner can fail; it may become noisy and/or the belt may jump off. Replacement of the failed tensioner will be necessary.

The ignition module or crankshaft position sensor may fail causing the engine to die and not restart. Diagnoses will be necessary to determine if the module or crank sensor is causing the no start condition.

The ignition coil housing may fail causing an engine misfire on one or more cylinders.

You may be able to prevent transmission problems by servicing the transmission and inspecting the fluid every 30,000 miles. If the fluid is dark or burned then the transmission system should be completely flushed.

The steering rack may develop a fluid leak or fail causing the steering to become hard to turn.

One or more of the fuel injectors may short out electrically causing a rough idle condition.

The PCV vacuum hose under the upper intake plenum may become brittle and crack causing an engine vacuum leak.

Extended life coolant may become contaminated and require cooling system service before the recommended 100,000 miles.

The timing chain tensioner and guides are prone to wear and may develop an abnormal noise, requiring replacement.

The 2.3L 4 cylinder engine can be prone to head gasket failure. This can result in coolant loss and engine overheating.

A dirty throttle body may cause a lower than normal engine idle resulting in a stalling condition. A stalling condition may also result if an idle learn procedure is not performed if the battery goes dead or is disconnected.

Front brake rotors can wear causing a pulsation felt in the brake pedal. Our technicians often recommend replacement of the front rotors and brake pads as the best option to correct this condition.

A coolant leak may develop from the water pump. This can result in an engine overheating condition. A leaking water pump will require replacement.