Chevrolet Astro Problem Reports

Newest Chevrolet Astro Problem Reports

Report A Problem

The spark plug wire rubber boots may get soaked with oil, causing a misfire or rough idle.

The distributor may develop internal faults. This can cause a rough running engine or stalling condition, the Check Engine Light may or may not illuminate. Our technicians tell us that the distributor should be overhauled or replaced to correct this concern.

The distributor may develop internal faults. This can cause a rough running engine or stalling condition, the Check Engine Light may or may not illuminate. Our technicians tell us that the distributor should be overhauled or replaced to correct this concern.

Illumination of the Check Engine Light may be the result of a loose or worn gas cap.

The EGR valve may stick open causing a rough idle and the Check Engine Light light to illuminate. Our technicians tell us that a piece of carbon may become stuck in the valve causing this problem. Cleaning the valve will usually correct this condition, in some rare cases the valve will need to be replaced.

The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Our technicians tell us that operating the engine  with a coolant/oil mix can result in internal engine damage. Replacing the intake manifold gasket should correct these leaks.

Vehicles equipped whit a 4 speed automatic transmission may develop a harsh 1-2 shift and/or illumination of the Check Engine Light with code P1870 stored. This can be caused by wear of the bore for the TCC isolator and regulator valves in the valve body. This condition does not commonly occur until the transmission reaches normal operating temperature. If the valve body is worn, replacement will be necessary to correct this concern.

Power brake systems using "hydro-boost" may leak power steering fluid from the hydro-boost unit located behind the brake master cylinder. Replacement of the hydro-boost unit is the common repair to correct this concern.

Vehicles using the enhanced vortec V6 engine may be hard to start run poorly and/or use to much fuel due to a fuel leak inside the intake manifold plenum. Commonly this is caused by a leaking fuel pressure regulator or fuel line. The fuel system will need to be pressurized with the upper intake manifold removed in order to determine the exact cause of the leak. Removing the "tuning valve" from the upper intake can allow for limited visual inspection without removing the upper intake manifold.

On vans with rear AC, the AC may stop blowing cold air due to a damaged AC line near the back of the engine. It is common for these lines to rub on the engine block, causing a hole in the line and a refrigerant leak.

An oil leak may develop from the distributor o-ring seal requiring replacement of the seal.

A fluid leak may develop from the transmission output shaft seal. This leak may cause the transmission mount to become oil soaked and require replacement of the mount along with the leak repair.

4.3L V6 multi-port FI only
The exhaust gas recirculation valve (EGR) may stick open causing a rough idle and the Check Engine Light to illuminate. Our technicians tell us that a piece of carbon may become stuck in the valve causing this problem. Cleaning the valve will usually correct this condition, in some rare cases the valve will need to be replaced.

A coolant leak may develop from the water pump. The engine may overheat as a result of the coolant loss. A leaking water pump should be replaced.