Chevrolet 2500 Pickup Problem Reports

Newest Chevrolet 2500 Pickup Problem Reports

Report A Problem

The power door lock actuators may become slow to operate or stop working completely and require replacement.

The anti-lock brake system (ABS) front wheel speed sensors are prone to failure. When a sensor fails, the ABS warning light may illuminate and/or the ABS system may activate erratically.

The throttle body gasket may develop a vacuum leak which may result in a higher than normal engine idle. Failed gaskets will require replacement.

A coolant leak may develop from the water pump. The engine may overheat as a result of the coolant loss. A leaking water pump should be replaced.

The windshield wipers may not work intermittently due to a faulty wiper motor control board. Our technicians tell us that lightly taping on the wiper motor when the fault occurs should temporarily get the wipers working again. Some vehicles were recalled for this problem and some were not. You will need to check with your local dealer to find out if a specific vehicle was included.

It is common for the fuel level sensor in the fuel tank read the fuel level incorrectly. The sensor must be replaced to correct the condition. Our technicians recommend having the complete fuel pump module replaced on high mileage vehicles.

The fuel pump may fail causing the engine to stall and not restart. Our technicians recommend replacing the fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.

The inside and outside door handles are prone to breaking.

The engine idle may be lower than normal due to deposits built up on the throttle body, which can restrict air flow at idle. To low of an engine idle can result in a stalling condition. Performing a throttle body service will generally correct this concern.

The anti-theft system may fail causing a no start condition, the security light may illuminate. Our technicians tell us that the ignition switch may need to be replaced to correct this fault.