Buick Problem Reports

RepairPal Verified Buick Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

The engine may develop a misfire due to worn valve seats. This fault will cause the Check Engine Light to illuminate. Replacement of the cylinder head may be required to correct this concern.

An ignition coil may fail causing one of the cylinders to misfire. Each of the two banks of cylinders has its own coil assembly. If one ignition coil fails the coil assembly for the corresponding cylinder bank must be replaced.

The mass air flow or crankshaft position sensor may fail causing the engine to intermittently stall. It may be necessary for the engine to cool down before it will restart.

The ignition coil housing may fail causing an engine misfire on one or more cylinders.

The mass air flow or crankshaft position sensor may fail causing the engine to stall intermittently. Proper diagnoses will be necessary to determine the cause of any stalling condition.

The ignition module or crankshaft position sensor may fail causing the engine to die and not restart. Diagnoses will be necessary to determine if the module or crank sensor is causing the no start condition.

The spark plug wire rubber boots may get soaked with oil, causing a misfire or rough idle.

The spark plug wire rubber boots may get soaked with oil, causing a misfire or rough idle.

The steering rack may fail causing the steering to become hard to turn.

The mass air flow or crankshaft position sensor may fail causing the engine to stall intermittently.

The transmission extension housing seal may leak fluid, replacing the worn seal will commonly correct this concern.

It is not uncommon for the power steering rack to develop a fluid leak requiring replacement of the rack assembly. Loss of power steering fluid may also cause an abnormal noise and damage to the power steering pump

.

The mass air flow or crankshaft position sensor may fail causing the engine to stall intermittently. Proper diagnoses will be necessary to determine the cause of any stalling condition.

When the heater only works on high, the most common problem is a blower motor resistor. The correct repair is to replace it with a new resistor.

Door lock mechanisms not operating properly. Doors may not lock/unlock.

Replacement of faulty door lock actuator required for proper operation.