Buick Park Avenue Problems

RepairPal has identified the most common problems with the Buick Park Avenue as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
×
Choose your vehicle
36
Known Problems

The mass air flow or crankshaft position sensor may fail causing the engine to stall intermittently. Proper diagnoses will be necessary to determine the cause of any stalling condition.

The mode and temperature door actuators may fail causing improper air flow or temperature output from the heating and AC (HVAC) system.

Illumination of the Check Engine Light can be caused by a loose or worn gas cap.

The outer tie rod ends on the steering linkage may wear causing excessive free play in the steering and uneven tire wear. If the worn tie rod ends are replaced, the wheel alignment should be checked and adjusted as necessary.

You may be able to prevent transmission problems by servicing the transmission and inspecting the fluid every 30,000 miles. If the fluid is dark or burned then the transmission system should be completely flushed.

General Motors recommends that the spark plugs should be replaced every 100,000 miles. Our technicians highly recommend the spark plug wires be replaced at the same time.

The spark plugs should be replaced every 100,000 miles. Our technicians recommend replacing the spark plug wires also at this time.

The spark plugs should be replaced every 30,000 miles and the spark plug boots should be checked for hot spots and cracks.

You may be able to prevent transmission problems by servicing the transmission and inspecting the fluid every 30,000 miles. If the fluid is dark or burned then the transmission system should be completely flushed.

The intake manifold gasket may develop external engine oil and/or coolant leak. The intake manifold will need to be removed and the gasket replaced to correct this issue.

The transmission pressure control solenoid may fail causing erratic shifting. Our technicians tell us that partial dis-assembly of the transmission is necessary to replace a failed pressure control solenoid.

The water pump may develop a coolant leak resulting in an engine overheating condition.

 

One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.