Chevrolet Camaro Problem Report
Chevrolet Camaro Power Window Not Working Due to Window Motor
A door window may move slowly or stop in mid travel due to a failing power window motor. The affected window may start working again after the motor cools off. Replacing the faulty window motor will commonly correct this concern.
Driver window quit working, replaced power window motor. - Visitor
windows have always gone up and down SUPER slow never bothered to try an fix it everybody sez 'it's a Camaro thing' - DrooliNtard
Passenger side window motor failed after a couple of months of slow operation. - Visitor
Window only moves centimeters at a time, usually an hour wait time - Visitor
Power window right stopped working had to replace motor. Thank good it was still covered under warranty. It has been one thing after another. When the warranty was up , only 20 mil. Over The fuel pump went out . And I take good care of my car , iam the only driver. Just now almost have 60,000 on her. And everything has broke down . Bought new , and I hate this car. And she's down again! Having coolant lose and fan not coming on now. - Visitor
Window switch and motor/regulator - driver side - Visitor
passenger side went 1st, replaced, went out again. Driver side then went. Getting replaced - Visitor
had it replaced 2 times - elcamino1971
Repaired under extended warranty plan -both windows, driver's side first, then passenger a few months later. - Visitor
window passenger side 3rd motor - sebringcamaro
repalaced windw motor - delane 72 garage and body shop
Driver window motor failed - Visitor
power steering fluid has been flushed and replaced. Power steering belt looks ok. car is starte...
The roller on the window guide attached to the bottom of the window glass may break off and cau...
I have a oil leak where the lower intake meets the block at rear of motor. I got a seal kit fro...
There is no power to the interior cab of my 1989 Camaro RS 2.8 L V6. No lights, radio, etc. C...
There is no power steering at this time. There are no codes present, but RPM's goes up and dow...