The ignition module or crankshaft position sensor may fail causing the engine to die and not restart. Diagnoses will be necessary to determine if the module or crank sensor is causing the no start condition.
1991 Pontiac Sunbird Problem Reports
Newest 1991 Pontiac Sunbird Problem Reports
It is not uncommon for the power steering rack to develop a fluid leak requiring replacement of the rack assembly. Loss of power steering fluid may also cause an abnormal noise and damage to the power steering pump.
It is very common for the high pressure power steering rubber hoses to leak. Our technicians recommend replacing leaky rubber hoses to prevent the loss of power steering.
One or more of the fuel injectors may short out electrically causing a rough idle condition.
The PCV vacuum hose under the upper intake plenum may become brittle and crack causing an engine vacuum leak.
The torque converter clutch can stick "on" after extended freeway driving causing the engine to stall when coming to a stop. Our technicians tell us when this occurs, the engine usually will restart and stall when put into gear. After allowing about twenty minutes for the engine and transmission to cool down, the engine will start and the transmission will operate normally. Replacing the torque converter clutch solenoid, transmission filter, and fluid will generally correct this issue.
A coolant leak may develop from the water pump. The engine may overheat as a result of the coolant loss. A leaking water pump should be replaced.
The rubber section of an automatic transmission cooler line may develop a fluid leak . In some cases the leaking section of hose can be replaced. In others, the complete cooler line must be replaced to correct this concern.
A dirty throttle body may cause a lower than normal engine idle resulting in a stalling condition. A stalling condition may also result if an idle learn procedure is not performed if the battery goes dead or is disconnected.
A door window may move slowly or stop in mid travel due to a failing power window motor. The affected window may start working again after the motor cools off. Replacing the faulty window motor will commonly correct this concern.
The engine temperature sensor wire for the engine temperature gauge, or warning light, may touch the rear exhaust manifold causing a short to ground causing erratic operation of the temperature gauge or warning light.