2000 Pontiac Grand Prix Problem Reports

Newest 2000 Pontiac Grand Prix Problem Reports

Report A Problem

The mass air flow or crankshaft position sensor may fail causing the engine to intermittently stall. It may be necessary for the engine to cool down before it will restart.

The crankshaft position sensor, ignition module, and/or powertrain control module (PCM) may fail resulting in illumination of the Check Engine Light with ignition system related fault codes stored in the PCM. Patience is necessary when dealing with this specific situation as normal diagnostic procedures are not effective. In many cases, the best option is to replace parts, one at a time until the fault is corrected.

The exhaust gas recirculation (EGR) tube which connects the EGR valve to the intake manifold may develop an engine vacuum leak, causing the Check Engine Light to illuminate with code P0171 and/or P0174 stored.

The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Our technicians tell us that operating the engine  with a coolant/oil mix can result in internal engine damage. Replacing the intake manifold gasket should correct these leaks.

Corrosion may develop at the connection between the ignition coil tower and spark plug wire resulting in an engine misfire. The Ignition coil and spark plug wire should both be replaced to correct this condition.

An engine oil leak may develop from the rear of the engine. This is commonly caused by a failed oil pump drive o-ring seal. The leaking o-ring should be replaced to correct this concern.

The water pump may develop a coolant leak resulting in an engine overheating condition.

 

The serpentine belt tensioner pulley may wear out. Our technicians tell us that in order to get a new pulley from General Motors you must purchase a complete belt tensioner assembly.

 

Acid may leak from the battery at the cable connections, resulting in corrosion on the battery cable ends and in the battery tray. A Leaking battery should be replaced and the cables thoroughly cleaned or replaced if necessary.

The automatic transmission shifter may fail, or a wire may break near the shifter causing the ignition key to become stuck in the ignition lock cylinder.

The transmission pressure control solenoid may fail causing erratic shifting. Our technicians tell us that partial dis-assembly of the transmission is necessary to replace a failed pressure control solenoid.

The fuel pump may fail causing engine to stall and not restart.

One or more power windows may stop working due to a failed window motor or switch. Proper diagnoses will be necessary to determine the exact cause.

The high pressure power steering hose will commonly leak fluid; it should be replaced.

The intake manifold gasket may develop external engine oil leak. The manifold gasket will need to be replaced to correct this issue.