17
questions

we replaced the window motor but now we think its the window switch wont raise the window up but will go down cant find a switch for 1994 grand prix

fixed coolant sensor some kind of seal. other cant rember all but coolant is full an light is still on. Fans do not work but got switch to turn them on when needed. Don't kno y the light is on and coolant is full please help

I need to know the procedure to reset all the sensors and basically the computer to the car
ECM PCM VCM o2 sensor, map sensor, so on.

What do you need to remove to change the high pressure hose on the power steering pump. Was able to get top hose off but having difficulty removing lower high pressure hose.

What do you need to remove to change the high pressure hose on the power steering pump. Was able to get top hose off but having difficulty removing lower high pressure hose.

What does it cost to replace the rear struts?

top caliper pin has some kind of silver cap with a rubber tab sticking out the middle of it.bottom pin has a bolt and can be removed with a socket.how do i get the top pin out.since it do,es not have anyway to turn it.like the bottom do,es.

always when on a bad road, all four shocks make the rattling noise.

HOW LONG TO REPLACE OIL PAN GASKET

I noticed that my traction control sysytem is defective since 11-19-10till now. the message on screen started to pop up since that time. it started to show up along with the problem. i quit driving my car because of the snow,whenever i drive it,it gets slipped and drifted left and right as if it is dancing. i was about to make car accident for 3 times because of it. it is snowing heavily lately in MT so i can't drive this car while it has this problem.please will you answer my question with details about this defect and how much does it cost me to repair it.

i need step by step instruction on how to change a rear window motor

My car is stuck in 1st gear and also wont go past 30 mph. The engine temp goes through the roof and the rpm's get up to 6000.

I recently changed my rear calipers and pads and brake hoses but when i go to bleed the calipers there is no brake fluid. what would cause this? so i said screw it i drove the car for 1 day with just the front brakes it was fine until the next day i went to drive it again and there were no brakes at all. i pumped the pedal for about 3min or so then it became hard again and the front seems fine there are no leaks and the fluid is full what wouldve caused this? kinda scared the brakes are gonna go out again when drive on the intersate.