2007 Pontiac G6 Problem Reports

RepairPal Verified 2007 Pontiac G6 Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

The fuel gauge may not read correctly and/or the Check Engine Light may illuminate with code P0455/P0461 stored for a fuel level sensor issue. These faults may be caused by a fuel vapor line inside the fuel take interfering with the fuel level sensor. If this is found to be the case, repositioned and securing the vapor line should correct this concern. If no fault is found with the fuel vapor line, the fuel level sensor itself may be at fault.

 

 

Vehicles with a 6speed automatic transmission may develop one or more of the following faults related to a broken 35R clutch wave plate inside the transmission: Illumination of the Check Engine Light with code P0716, P0776, P0717, P0777, P2714, P2715, and/or P02723, loss of reverse gear, slipping or harsh 3rd or 5th gear shift. Removal and dis-assembly of the transmission will be required to replace the broken 35R wave plate. It is also extremely important that all debris from the failed part be cleaned from the transmission while it is disassembled in order to try and prevent future problems.

Illumination of the Check Engine Light can be caused by a loose or worn gas cap.

Various electrical issues may be caused by poor terminal contact at the body control module (BCM) electrical connectors. Proper diagnoses will be required to confirm faults are related to poor BCM connections.

Various issues with the electric power steering system may develop and could require replacement of steering column assembly.

Vehicles with a 3.5L or 3.9L V6 engine may develop an engine oil leak from the front crankshaft seal. Our technicians tell us a revised front crankshaft seal is available to correct this concern.

Vehicles with certain V6 engines may illuminate the Check Engine Light one or more of the following codes: P0011, P0014, P0021, P0024, P0341, P0346, P0336, or P0391. Our technicians tell us that some vehicles may require a powertrain control module (PCM) software update to correct this issue. Other vehicles may have excess camshaft end play on one or both cylinder heads which will need to be corrected using special procedures outlined by GM.