Problem Reports

A dirty throttle body may cause low engine idle speed or frequent stalling, as oily residue blocks air flow in the throttle when the throttle is closed. Throttle body cleaning may be necessary to correct this condition. Our technicians caution against spraying cleaner directly onto the throttle body as this may damage the throttle position sensor (TPS).

Illuminated of the airbag warning light may be caused by a lost connection between the clockspring (behind the steering wheel) and the steering wheel-mounted electrical components. Other steering wheel-mounted controls like the horn, speed (cruise) control, or radio controls (if equipped) may be inoperative. There is a lifetime warranty on the clockspring as specified in a combination of recall campaigns. For more information on these recalls please us the following links; 1996-1998 models, please click here». For 1998-2000 models, please click here»

A momentary loss of power steering can occur when the AC or defroster is on during high humidity conditions. This is due to condensation from the evaporator draining onto the serpentine belt.  To fix the problem, a spout on the AC evaporator drain and a new serpentine belt should be installed. Some vehicles may need a revised serpentine belt tensioner.

On higher-mileage vehicles, engine oil leaks from the valve covers and front crankshaft seal are common.

A malfunctioning switch in the steering column can cause the front windshield wipers to self-activate or not turn off. A failed windshield switch will require replacement.

When braking during low speeds (under 10 MPH), the brake pedal may vibrate and the ABS hydraulic unit may cause a rumbling noise. This is caused by a momentary loss of the wheel speed signal to the ABS controller. Adjusting or replacing the wheel speed sensor will commonly fix this problem.

Hood misalignment, cowl cover misalignment, wiper module drain tube(s), and/or the lower plenum drain hose may cause the HVAC housing to leak water onto the passenger side floor. Diagnoses will be required to confirm the location of a water leak in the front passenger area.

One or more power windows may stop working due to a failed window motor or regulator. In some cases these items are replaced as a set. If not, diagnoses will be required to determine which is at fault.