1999 Plymouth Grand Voyager Problems

RepairPal has identified the most common problems with the 1999 Plymouth Grand Voyager as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
Choose your vehicle
Known Problems

One or more power windows may stop working due to a failed window motor or regulator. In some cases these items are replaced as a set. If not, diagnoses will be required to determine which is at fault.

Illuminated of the airbag warning light may be caused by a lost connection between the clockspring (behind the steering wheel) and the steering wheel-mounted electrical components. Other steering wheel-mounted controls like the horn, speed (cruise) control, or radio controls (if equipped) may be inoperative. There is a lifetime warranty on the clockspring as specified in a combination of recall campaigns. For more information on these recalls please us the following links; 1996-1998 models, please click here». For 1998-2000 models, please click here»

Worn sway bar bushings or sway bar end links may cause a rattling or clunking noise from the front suspension during low-speed driving. Though not always the root cause, front struts are often replaced for this condition.

When braking during low speeds (under 10 MPH), the brake pedal may vibrate and the ABS hydraulic unit may cause a rumbling noise. This is caused by a momentary loss of the wheel speed signal to the ABS controller. Adjusting or replacing the wheel speed sensor will commonly fix this problem.

Some vehicles may develop a musty odor coming from the HVAC system, Dodge has issued a cleaner/disinfectant and a coating for the evaporator designed to inhibit bacterial growth.

On higher-mileage vehicles, engine oil leaks from the valve covers and front crankshaft seal are common.

Common areas for engine oil leaks include the camshaft plug, camshaft seal (sprocket end), valve cover gaskets, cylinder head gasket and distributor.

Timing cover oil and coolant leaks are common, the oil and coolant don't normally mix. Our technicians recommend to replace the timing chain and cam sprocket if the timing cover is removed to reseal - or for any other reason.

A loose timing chain on early models will produce a rattle (in the front of the engine) because the chain hits the guide. The timing chain should be replaced (the cam sprocket should always be replaced at the same time). Remove and discard the timing chain guide; on later V6 models, the guide has been eliminated.

Defective speed sensors on the transmission can cause problems with the cruise control and speedometer operation, as well as erratic shifting. The connectors on the sensors can corrode and/or the connector terminals can spread (poor connection), which will create similar symptoms. Any of these problems can cause Check Engine Light illumination.

Intermittently, the key may not start the car or release from the ignition. If it is excessively worn, replace the key. If the new key doesn't work, replacing the lock cylinder including tumblers should correct this concern.

A dirty throttle body may cause low engine idle speed or frequent stalling, as oily residue blocks air flow in the throttle when the throttle is closed. Throttle body cleaning may be necessary to correct this condition. Our technicians caution against spraying cleaner directly onto the throttle body as this may damage the throttle position sensor (TPS).

The speedometer may become inoperative due to a failed vehicle speed sensor (VSS), . A failed sensor will require replacement.

A delay in the transaxle engagement (greater than three seconds) may have multiple causes, including a defective pump, defective internal lip seals, valve body components, park-reverse-neutral-drive lever switch, and the output speed sensor. Proper diagnoses will be necessary to determine the exact cause.