Parking break is released. Warning light still showing on dash. When in motion light blinks, along with a dinging sound. When not in motion it stops..I tried many times applying break then releasing it. Ive looked under dash to see if theres a reset button or a wire that is attached to the break pedal so i can disconnect it..I cant find anything.. Can you please suggest anything that will help temporarly with the chime to be turned off til i have the funds to repair or replace it..Ive been driving with the radio on high so I dont lose it with the chime going off.. Thank you!!
GMC Q&AAsk Your Question
2004 GMC Yukon Question: Pls.HELP!! How do I get the parking warning light off dash
Answer #1pushrod September 02, 2013, 09:34Master
Check the brake fluid level in the master cylinder to start with. If it is low, it will also turn on the light. If you pull up on the park brake pedal and the release at the same time, does the light go out? There is a wire connector that can be unhooked, difficult to see though! I am sure there is also a fuse that can be removed but no way to tell what else may be affected.
Replylady671, September 02, 2013, 09:40Rookie
Nope...it stays on.. Break fluid level is full. Is there a certain color or look to this connector?? Ive disconnected 2 but they werent the one.. N where exactly its located.. :)
Replypushrod, September 02, 2013, 09:43Master
Have a mechanic look at it or just ding on!! That's it.
Replylady671, September 02, 2013, 09:46Rookie