Q&A

2000 Toyota Corolla

Question: PCV Valve Problem.

Question

Go Joe, Advance, NC, May 19, 2009, 19:53

 Enthusiast

Is the PCV Valve for this car on the valve cover or on the block? Where is it? On ft or rear side? Accessible from above or below? When removing the valve does any oil escape? Can a shade tree mechanic change this part? When changing ther PCV valve are there any other hoses or clamps recommended to be replaced?

1 Answer

Answer It

Flag This

Follow this Question Unfollow this Question

• Answer #1

  patrick mannion from Greg Solow's Engine Room, May 19, 2009, 20:57
  

   Master

  The PCV valve screws into the valve cover on the oil filler cap side of the Valve Cover (other corner). It is straight forward easy to replace, no oil spills out, change it of course with the engine switched off should take you 5 to 10 minutes.
  Reply
  Flag This
  Like | 2 people like this2

• Where is the pcv valve located? & what can cause the temperature meter to go up?
  i was told that the pcv valve should be change along with the sparks...problem is i dont know were is it located

  Q&A > Toyota > 2000 Toyota Corolla

• PCV HOSE replace
  I have the OEM PCV valve and have a hard time getting the hose to inserted into the PCV valve and the other end that go...

  Q&A > Toyota > 1997 Toyota Corolla

• spitting oil
  My car which has 146000 miles on it with the engine being replaced at 100000 mile has had some problems lately holding oil. On drive over an hour the oil is being spayed into the engine compartment...

  Q&A > Toyota > 1992 Toyota Corolla

• pvc change
  I was told i need to change the PVC valvue on my 2010 corolla 1.8 lt by the dealer. the car has 16,287 miles. does that make sense and how do I change it?

  Q&A > Toyota > 2010 Toyota Corolla

• pvc valvue change
  can you provide instructions on changing the PVC valvue on my 2010 1.8lt toyotta corrola

  Q&A > Toyota > 2010 Toyota Corolla