Q&A

2004 Chrysler Sebring

Question: PADS & ROTORS

Question

MICHAELP4514, 2.7L V6, Bay Shore, NY, March 07, 2010, 11:05

 Enthusiast

WHAT ARE THE BEST TYPE OF PADS AND ROTORS TO INSTALL ON THE CHRYSLER ABOVE.....

2 Answers

Answer It

Flag This

Follow this Question Unfollow this Question

• Answer #1

  dandd March 07, 2010, 11:16
  

   Master

  Factory, bar none.
  Reply
  Flag This
  Like | 1 person likes this1
• Answer #2

  Visitor, February 27, 2011, 11:37

  If they arent worn too bad see if you can find an old mom and pops place to "Turn the Rotars". Which means they will send them of to be lightly grinded down to were they are even and it wont wear your break pads out fast. Plus it cost about $80.00 to do one versus paying a butt load of money to get a new rotar. If no I would try to find a junk yard and see if you can get them there.

  Get the ceramic pads they cost about 40$ for to a pair but they have a lifetime guarentee.
  Reply
  Flag This
  Like0

• Brake travel all the way to the floor
  I am trying to get a 1998 Sebring through inspection and it failed for the brake pedal travel to the floor. The brake pressure was good and the brakes seem to work normal. I replaced the fluid and ...

  Q&A > Chrysler > 1998 Chrysler Sebring

• car vibrates when i put on brakes
  I had new brakes installed in November of 2008. For the past month, sometimes when I am stop, my car feels like is vibrates in the front and my steering wheel shakes a bit. What could this be?

  Q&A > Chrysler > 1998 Chrysler Sebring

• Brake Problem
  The pads, calipers and rotors are good. I have replaced the master cylinder and have bled the lines. While bleeding the lines the peddle gets tight but will still bleed slowly to the floor. When th...

  Q&A > Chrysler > 1999 Chrysler Sebring

• front end vibration
  My car has a vibration in the front when I apply the brakes, to slow down or come to a stop.

  Q&A > Chrysler > 2007 Chrysler Sebring

• brake pedal to the floor first time. fine after the 1st. bled all lines twice
  ...ll 4 lines twice and checked them to make sure none r dry rotted. still able to push the brake pedal to the floor the 1st time but after the first push pressure is ok. but if im goin 60 on the hi...

  Q&A > Chrysler > 2006 Chrysler Sebring