Problems for specific Oldsmobile Cutlass Supreme years:

Car problem reports

Report A Problem

Problem with your car? See what our experts say or submit your own.

Repairpal verified 1992 Oldsmobile Cutlass Supreme problems

 

Verified for the Oldsmobile Cutlass Supreme

The ignition module or crankshaft position sensor may fail causing the engine to die and not restart. Diagnoses will be necessary to determine if the module or crank sensor is causing the no start condition.

7 Reports
Me Too

Verified for the Oldsmobile Cutlass Supreme

The water pump may develop a coolant leak resulting in an engine overheating condition.

 

11 Reports
Me Too

Verified for the Oldsmobile Cutlass Supreme

A stalling issue may occur if the battery goes dead or is disconnected and the "idle learn" procedure is not performed. For more information on "relearning" the engine idle speed, please click here»

4 Reports
Me Too

Verified for the Oldsmobile Cutlass Supreme

An engine oil leak may develop from the oil pump drive O-ring. This can often be confused with an intake manifold gasket leak. Careful inspection is required to determine the exact cause of the leak. Replacement of the failed 0-ring will commonly correct this concern.

12 Reports
Me Too

Verified for the Oldsmobile Cutlass Supreme

The upper intake manifold gasket and/or a PCV vacuum lines/hoses can develop vacuum leaks with age. This type of leak can result in a higher that normal or rough idle.

19 Reports
Me Too

Verified for the Oldsmobile Cutlass Supreme

The fuel pump may fail causing engine to stall and not restart.

13 Reports
Me Too

Verified for the Oldsmobile Cutlass Supreme

The rubber section of an automatic transmission cooler line may develop a fluid leak . In some cases the leaking section of hose can be replaced. In others, the complete cooler line must be replaced to correct this concern.

10 Reports
Me Too

Verified for the Oldsmobile Cutlass Supreme

Body: A dirty throttle body may cause a lower than normal engine idle resulting in a stalling condition. A stalling condition may also result if an idle learn procedure is not performed if the battery goes dead or is disconnected.

4 Reports
Me Too

Verified for the Oldsmobile Cutlass Supreme

The oxygen sensor can fail causing Check Engine Light illumination and the engine to run rich (burn more fuel than normal).

4 Reports
Me Too

Verified for the Oldsmobile Cutlass Supreme

The high pressure power steering hose will commonly leak fluid; it should be replaced.

14 Reports
Me Too

Verified for the Oldsmobile Cutlass Supreme

The engine temperature sensor wire for the engine temperature gauge, or warning light, may touch the rear exhaust manifold causing a short to ground causing erratic operation of the temperature gauge or warning light.

5 Reports
Me Too

Verified for the Oldsmobile Cutlass Supreme

Fuel injectors can short-circuit electrically causing a rougher than normal idle and reduced performance.

5 Reports
Me Too

Verified for the Oldsmobile Cutlass Supreme

The Engine Control Module (ECM) can fail causing stalling, and engine and transmission drivability concerns.

9 Reports
Me Too

Verified for the Oldsmobile Cutlass Supreme
The timing belt may fail prematurely. Our technicians tell us that the belt tensioner and idler pulleys should be replaced when the timing belt is replaced.
6 Reports
Me Too

Verified for the Oldsmobile Cutlass Supreme
Air flow from the dash vents may be incorrect due to a damaged engine vacuum hose near the battery tray.
6 Reports
Me Too
Ask a Question