Illumination of the Check Engine Light can be caused by a loose or worn gas cap.
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 1999 Oldsmobile Cutlass problems
The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Our technicians tell us that operating the engine with a coolant/oil mix can result in internal engine damage. Replacing the intake manifold gasket should correct these leaks.
An engine oil leak may develop from the rear of the engine. This is commonly caused by a failed oil pump drive o-ring seal. The leaking o-ring should be replaced to correct this concern.
A coolant leak may develop from the water pump. The engine may overheat as a result of the coolant loss. A leaking water pump should be replaced.
The engine may start and stall with the security light flashing. This is commonly caused by a failed passlock sensor which is part of the ignition lock cylinder. A secondary cause could be the ignition switch itself. Worn contacts inside the ignition switch can cause voltage drop issues which can affect the passlock system. Proper diagnoses should be performed before replacing any parts.
An automatic transmission fluid leak may develop from the rubber section of a transmission cooler line. In some cases the rubber section of hose can be replaced. In others, the complete cooler line must be replaced to correct this type of leak.
The high pressure power steering hose will commonly leak fluid; it should be replaced.
The front struts may show signs of wear, or be excessively bouncy ride at freeway speeds. This may begin to occur at around 75,000 miles.
The turn signal switch may fail causing the turn signal flasher to continue to click after the turn signals are turned off.