Q&A

1994 Jeep Wrangler

Question: oil pressure sending unit

Question

gabrielcr, 4 Cylinder, Beverly Hills, CA, September 10, 2009, 22:02

 Rookie

Where is the oil pressure sending unit sensor located?

1 Answer

Answer It

Flag This

Follow this Question Unfollow this Question

• Answer #1

  dandd September 11, 2009, 13:07
  

   Master

  On the side of the engine near the oil filter.
  Flag This
  Like | 4 people like this4
• Reply

  Visitor, May 16, 2011, 09:25

  I just found out the hard way, this can go bad and allow all your oil to spray out. Luckly I was close to home and dont think I did a lot of damage running out of oil???? Mech is still checking it out.
  Reply
  Flag This

• oil pressure gauge
  my oil pressure gauge has been showing mid range at 40---it suddenly shows almost zero to 10---no engine noise or misses in running-is this a gauge problem?

  Q&A > Jeep > 1993 Jeep Wrangler

• Connectors to Oil Pressure unit
  The connectors (black) to the oil pressure switch has two sides. The side of the connector that attaches to the wiring (green) to the guage has a back plug that keeps popping out ( its white) and a...

  Q&A > Jeep > 1992 Jeep Wrangler

• Oil pressure
  My wrangler oil gauge use to read in the middle of the gauge. Now it is pegged out on the high end. Everything else seem fine. Oil is full and is running fine.

  Q&A > Jeep > 1995 Jeep Wrangler

• oil pressure safety switch
  oil pressure has been running high, like 80 when running 45 to 60 miles per hour. purchased oil pressure safety switch but need to find out where it is on engine?

  Q&A > Jeep > 2002 Jeep Wrangler

• Engine Oil Leaks From Valve Cover, Oil Pan, and Timing Cover Gaskets
  Engine oil leaks from the valve cover gasket, oil pan gasket and timing cover gasket are common...

  Common Problems > Jeep Wrangler