Rented a computer scanner code 37 came up and read tranny temp. sensor voltage high would it have anything to do with me not getting fire to spark plugs. i done changed the ignition coil rotor boug distributor cap and the pick up coil what else can it be?
not getting fire to spark plugs on 1994 Dodge Ram 1500
by fisher1476 in Stilwell, OK on September 09, 2010
ANSWER by Johnny Mopar on September 13, 2010
Code 37 has no relation to your concern. Code 37 is for the A/C Clutch relay. There could be many reasons for a no spark condition. In your case your Crankshaft position sensor and or wiring could be defective. Without this input to your Powertrain Control Module (PCM), your engine will not start.
With the bad motor I was getting fire to plugs but now with new motor I am not getting fire to spark plugs. Why?
I have a engine wiring problem with my 1994 Dodge Ram 1500; When I drive in forward gear the en...
just redid the timing on dodge ram driver side is hitting but passeganer side is not getting fire
I have replaced the fuel pump. I am getting fuel pressure from the fuel rail. I am getting fire. It will crank but not start. What would be the next step to take to get the truck started?