no start on 1992 Mazda B2600

no start installed new dis ,coil ,plug ,and wires still no spark does this truck have a main relay? any ideas what up

by in Eldridge, IA on June 21, 2011
1 answer
ANSWER by on June 21, 2011
you need to verify voltage to the coil. it has to have 12 volts with the key on. from there, it gets a bit more complicated and needs someone who understands the system to find the failure. you have replaced all the basics, now you need help finding the real problem before spending more money for nothing. let a shop check it for you to find the failure. Roy
Related Items:
i can spray starting fluid and it will start and run. turn the truck off and it will not start on its own. you will have to start it with fluid again.55 lbs fuel pressure.have spark.............
...M IS INTERMITTENT ACCORDING TO MECHANIC--WILL START A FEW TIMES, AND THEN WILL ONLY CRANK WITH NO START AFTER IT SITS FOR A DAY OR SO--DOES FUEL PUMP IN GAS TANK NEED REPLACEMENT?? MECHANIC SAYS IT...
If the engine cranks but won't start, the fault may be internal to the distributor. Diagnosis will show no spark and trouble codes for the crankshaft position sensor (CKP) or the camshaft position ...
the mazda bravo was starting and you could drive it but when you turn it off it will not start, have changed the spark plugs, rota coil and auto fuel pump it started for abit and now it wont start ...
1993 B2600i g6 f/i asperated motor. overheated, blew head gasket. replaced but now wont start. im very sure all setting are correct, but never hurts to check. with crank at tdc 0 were should the ca...