no spark on 1995 Dodge Grand Caravan

the serpentine belt just came off didnt break tho, put it back on and now the van wont start. What can I check. Is there a crank shaft sensor?Any ideas?

by in Afton, NY on February 18, 2010
1 answer
ANSWER by on February 18, 2010
The crankshaft position sensor on your 1995 Dodge Grand Caravan should be located at the back of the engine near where the transmission bolts to the engine block. The serpentine belt falling off should not affect the crank sensor. If you are sure you don't have spark then try checking the connections and the wiring going to the ignition coil which is normally mounted just above where the serpentine belt rotates. Please look over the following Q&A link for more information on why the serpentine belt may have come off in the first place -
Related Items:
I replaced crank sensor, cam sensor, coil pack, checked timing chain ( good ). Still no spark or fuel. Found a white fusible link that was melted, there is the white one, and an orange one...
Recently, the service engine light came on, and when I pulled the code it came back P0305, which I now know has to do something with a misfire in the #5 cylinder of my V6 4.0L engine. At the same ...
As per my previous post I replaced the PCM on my 1996 Grand caravan which started out as PCM not sending a signal to to 2 cyl's on the coil pack. Purchased a reman PCM and it started right up but h...
Engine has no power and drags when trying to accelerate like it has no vacuum advance, diagnostic says it is missing on #2 and #5 cylinders. Changed coil pack with no change.

Related Content