no power on 1990 Ford E-250

Engine bogs down under load when warmed up.

by in Campbell, CA on June 27, 2010
1 answer
ANSWER by on July 18, 2010
Have you tried a tune up. If so may be a distributor or cat converter problem.
Related Items:
2000ford van starts ok runs but has no power at all will hardly pull no trouble codes when scanned tryed o2sensor right bank by engine scan...
I have checked fuel pressure and performed a fuel volume test. I disconnected all 3 catalytics and drove, same problem. When I cycle the ignition while running the engine accelerates fine 2 times, ...
I have codes , But with the Generic scanner , It cannot be trusted . It will start , but will not excell. I have tested all circuits , and changed all electronics , with a know good part . Still wo...
pedal fades while engine is running and brakes pull to the left upon hard braking ,replaced both front calipers too.could air be trapped in abs unit ? no codes on computer
I added a new alternater and battery and van still wont stay running..battery charge indicator goes dead within a few minutes of starting then van won't start at all

Related Content