no crank on 2004 Chrysler Pacifica

engine doesn't crank I jump out the solenoid on the starter and it starts right up.Check the rely and 40 amp fuse all okay. Could be neutral safety switch or ignition. Is there any other solenoid or inline fuse that could be bad????

by in East Islip, NY on March 18, 2009
2 answers 1 comment
ANSWER by on March 18, 2009
probably the ignition switch has failed, I think you can test the neutral safety switch by jumping it with a piece of wire. Napa , airtex, Borg warner, all carry the ignition switch so it must be a common part that fails
COMMENT by on July 01, 2010
where is the neutral switch locate how to find it chrysler pacifica 2004
ANSWER by on February 06, 2012
My 2006 Pacifica would not start when I turned the key it just clicked took it in and Chrysler garage says it is the fly wheel and it will take 9 hours to repair. So now waiting for fly wheel to be changed. Just replaced timing belt and water pump one week ago with same Chrysler garage.
Related Items:
it is getting gas and is also firing but still will not crank.
07 Pacifica refuses to start intermittently. A local shop says the computer is at fault. Even tho the car is under warrenty, Chrysler refuses to do anything about it, even refusing to pay the tow...
this happens every time hot or cold don't not getting any codes.
My car will crank and crank until I turn the key back, and does that 3 times before it till start hard like its not getting gas. Once I step on the gas pedal it will start up. Runs fine once it goe...
My Pacifica won't crank, not even a click. New battery, ground and starter connections checked and OK. When I turn on the ignition the "in dash" transmission gear indicator letters (P R N D 8autost...

Related Content