Nissan Recalls

Models : Nissan Quest
Body, Interior & Misc., January 12, 1996
Summary:LEAVES AND OTHER FOREIGN MATERIAL CAN ENTER THROUGH THE COWL PANEL AIR INTAKE DURING OPERATION OF THE FRONT HEATER AND/OR AIR CONDITIONING SYSTEM RESULTING IN A BUILD-UP OF MATERIAL IN THE PLENUM. THIS CAN LEAD TO NOISE, ODORS, OR IN SOME CASES, IGNITION OF THESE MATERIALS.
Models : Infiniti M30, Infiniti Q45, Nissan 240SX, Nissan Pathfinder, Nissan Sentra
Body, Interior & Misc., September 29, 1995
Summary:THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.
Models : Nissan Altima
Brakes, February 20, 1995
RepairPal Expert Overview:

Nissan is recalling 1995 Altimas because the brake hose for the right rear wheel was routed incorrectly and may make contact with a suspension component, causing abrasion to the hose and eventual leakage. A leaking brake hose reduces braking capability, increases stopping distance, and increases the risk of an accident. Dealers will replace or re-route the right rear brake hose.

Models : Nissan 200SX, Nissan Sentra
Brakes, February 18, 1995
Summary:THE ANTI-LOCK BRAKING SYSTEM (ABS) HYDRAULIC ACTUATOR WAS NOT PROPERLY PURGED OF ALL AIR DURING THE FILL AND EVACUATION PROCESS CAUSING AIR BUBBLES TO GET INTO THE BRAKE SYSTEM.
Models : Nissan Pickup (D21)
Brakes, February 2, 1995
Summary:THE RIGHT FRONT BRAKE CALIPER PISTON SEAL GROOVE WAS IMPROPERLY MACHINED CAUSING A BRAKE FLUID LEAK WHEN THE BRAKES ARE APPLIED.
Models : Nissan Pickup (D21)
Body, Interior & Misc., January 20, 1995
Summary:TRUCKS WERE ASSEMBLED WITHOUT A DOOR LOCK PLATE IN THE RIGHT SIDE DOOR.
Models : Nissan Maxima
Drive Train, November 30, 1994
RepairPal Expert Overview:

Nissan has recalled 1993-1994 Maxima models because the aluminum wheels were excessively clear coated, which can leave too much distance between the wheel nuts and the wheel hub. This can cause the wheel nuts to loosen over time, causing the hub bolts to break and the wheel to separate from the vehicle. Dealers will remove the clear plastic coating from the brake rotor mating surface on the back of each wheel and from the wheel nut mating surfaces. The wheels will be reinstalled and the wheel nuts tightened.

Models : Nissan Altima
Drive Train, October 17, 1994
RepairPal Expert Overview:

Nissan is recalling certain 1995 Altimas because the shift lever lock plate, which prevents the shift lever from being inadvertently moved from the "Park" to "Drive" or "Neutral" position, can be broken by the transmission shift position pin. This can cause vehicle movement, which may result in a crash. Dealers will install a bracket to prevent the shift position pin from breaking the shift lever lock plate.

Models : Nissan 240SX
Brakes, August 19, 1994
Summary:THE INSTRUMENT PANEL BRAKE WARNING LIGHT WILL NOT ILLUMINATE WHEN THE BRAKE FLUID LEVEL IN THE MASTER CYLINDER DROPS SUFFICIENTLY TO ACTIVATE THE LOW LEVEL SWITCH DUE TO AN IMPROPERLY WIRED DIODE, REQUIRED BY FMVSS NO. 105, "HYDRAULIC BRAKE SYSTEMS."
Models : Nissan Maxima
Body, Interior & Misc., March 15, 1994
RepairPal Expert Overview:

Nissan has recalled 1992-1993 Maxima models because in certain underbody impacts, the air bag sensor may activate and send a signal to the air bag, located in the center of the steering wheel, causing the driver's side air bag to inflate when it is not needed. This may result in minor injuries to the driver. A tunnel sensor of different design will be installed on affected vehicles.