These trucks are being recalled because an electrical circuit breaker may have been incorrectly installed behind the lower left portion of the dashboard. As a result, a bolt may wear through the wire harness covering causing an electrical short circuit. This could result in a fire. Dealers will inspect and repair the wire harness and circuit breaker as necessary to correct this concern.
Nissan Frontier Recalls
Certain vehicles may have been equipped with front wheel hubs that may not meet the design hardness specifications. A wheel hub that was manufactured below hardness specification may wear prematurely and eventually crack. If the vehicle is driven in this condition, the wheel hub may break, possibly resulting in a vehicle crash. Dealers will replace the left and right side front wheel hub assemblies to correct this concern.
Some of the bolts that attach the engine oil cooler and filter to the engine may have been manufactured below specification strength. As a result, the bolt may break at the oil filter attachment point, which can cause an engine oil leak. Loss of too much engine oil can result in loss of oil pressure and the engine could seize, increasing the risk of a crash. Dealers will replace the connector bolts to correct this concern.
Nissan is recalling 2002–2004 Frontier and Exterra models due to corrosion in the lower steering column joint that can limit movement of the joint, resulting in excessive load. This can lead to cracking of the shaft, which may result in loss of steering control, increasing the risk of a crash. Nissan will replace the steering column shaft and joint with a different design, free of charge.
Nissan is recalling 2008–2010 models equipped with Garmin Nuvi 750 navigation systems because the battery may overheat, which could lead to a fire. Nissan will notify owners and Garmin technicians will replace the unit's battery and insert a spacer to prevent the problem from reoccurring. This will be performed free of charge.
Nissan is recalling 2010 Frontier King Cab models for failing to comply with federal safety standards concerning child restraint anchorage systems. The weld between the tether anchor and seat gusset bracket is out of specification. This can cause the tether anchorage to separate from the vehicle seat, increasing the risk of injury. The tether anchorage will be replaced free of charge.
Nissan is recalling certain 2004 - 2010 Titan, Armada, & QX56 vehicles. Also included are 2005 - 2010 Frontier, Xterra, and Pathfinder vehicles for faulty front and/or rear suspension lower control arms. The problem is the control arm's attaching point to the vehicle's chassis. During the manufacturing process, some control arms may contain welds that do not meet Nissan's strength specs, and if they break, it may result in loss of vehicle control, and a possible crash.
Welds on the mounting collars of the front lower control arm may not meet specifications. A failed control arm increases the risk of a crash. Dealers will repair the vehicles as necessary. This recall is scheduled to begin by May 20, 2010.
The molded fuel tank can warp, creating interference with the fuel sender float arm and fuel tank. This would cause the fuel gauge never to read below a quarter tank of fuel even if it's empty. If the vehicle runs out of gas in traffic, you might become stranded or get into an accident. Dealers will replace the fuel level sending unit with one that has a modified float arm. The recall began March 22, 2010.
The air bag crash sensors located in the front zone may have corrosion buildup due to a high level of road salt exposure. If this happens, the sensor may become inoperative, and the air bag light will come on. If this happens, the air bags will not deploy in a collision. This recall began on January 26, 2009.