3.5 l v6 scan code was po340
Q&A
Ask Your QuestionAll 2005 Nissan Altima
Question
are there more than 1 cam sensor and where are they located ?
Question
my altima acts like it slips into neutral only when i have to really step on gas
when i give it gas normal it is fine but if i have to stompon gas it acts revs high and acts like...
Question
car wont start sometimes
cleaned battery terminals and tightend. sometimes just klicks but does start after trying 3 to 5...
Question
car wont start sometimes when turning the key just klicks, but after trying 3 t
2005 altima sometimes will not start when turning the key just clicks after trying 3 to5 times i...
Question
2.5 s heat while moving cold when at idle heater control valve is it heat con va
where is heater control valve/
Question
y is my 2005 nissan altima sputtering when i stop and did it 2day while driving
it sputters when at idle and a complete stop and today it did it while i was driving it 2day
Question
2008 Acura MDX charging system issues
Thinking of purchasing a 2008 Acura MDX w/Tech package. Reviewed the free Carfax report. In 5 yea...
Question
Does a rusty undercarraige get better with time?
I have a 2005 Nissan Altima that has been through 7 winters. The undercarriage has a lot of rust,...
Question
My fuel gauge on the dash isn't working properly.
When I fill up with gas, the gauge only registers half full, but the tank is full. The dte shows ...
Question
Clutch pedal stuck and car wouldn't start
When I got off a traffic light and tried to shift gears heard some breaking sound and the clutch ...
Question
What would cause a water noise in the dashboard?
water noise when turning
Question
my 2005 nissan altima serpentine belt keep coming off what could be the problem
its fine for a while but all of a sudden the belt comes off put on a new belt last about a month ...
Question
what would cause no fire to cylinder 4 to my nissan altima 2.5L engine?
I have replace both crank and cam position sensors,placed injectors, replaced spark plugs, and sw...
Question
What does it cost to replace the motor mounts ?
The existing mounts are worn
Question
this car had a blown head gasket, and a new timing kit, when started had rod kno
so we broke it down again and did rod bearings. started and runs perfect except when you accel th...
This week's top 10
| 1 globalhelper | 6 FREDDY BLUE |
| 2 pushrod | 7 csubak30 |
| 3 ziptie12 | 8 ebans777 |
| 4 ChevyASE | 9 gearhead89 |
| 5 wenyan | 10 corvairart |