Get the latest advice about your car

Get Started
Advice » Q&A » 1997 Ford F-250

Q&A

Ask Your Question

1997 Ford F-250

Question: need to locate and change oil sending unit on 4.6 liter Triton V8

Question

cord, 4.6L V8, Oregon House, CA, March 11, 2011, 20:26
Profile_thumbnail
 Rookie

After first starting the engine, the oil pressure gauge reads normal and within the first ten seconds the gauge drops to nothing and wont go back up at all. My first thought was to replace the sending unit yet I cant seem to locate it. I would also like to know how to remove it, if its not obvious removal. (1997 ford F250 4x4 w/4.6 Lit. Triton)

1 Answer
Answer It
Flag This

  • Answer #1

    raiderron March 11, 2011, 20:42
    Profile_thumbnail
     Master

    Found this online:

    The switch is going to be mounted into the same chunk of metal that the filter screws onto. Actual location depends on whether 2WD or 4WD.
    Single plug-on wire connector, usually can be removed with a socket.
    I'd suggest replacing it during your next oil change. Keeps the mess down.
    Slightly different location on the 4x4 model. Remove the drivers side wheel, then can access the switch located on a metal fitting on the side of the engine just above the front axle gearcase. Follow the hoses from the remote oil filter housing back to the engine and there it is.

    Reply
    Flag This
Answer Ranks

This week's top 10

1 globalhelper 6 Autohaus Lake Norman
2 milesauto 7 TimGoodreau
3 csubak30 8 raiderron
4 jose8889 9 Merrimack Auto
5 obdcar 10 Camster